M.A. Ford
M.A. Ford CXDSS4375AP Cyclone Xd 3X Solid Double Margin Drill 7/16 pneumatic accessory
7/16 inch solid double margin drill for pneumatic drilling applications
- 3X drilling efficiency with Cyclone Xd design
- Solid double margin construction for precise hole accuracy
- 7/16 inch diameter suited for pneumatic applications
- New condition ensures full factory performance
- M.A. Ford quality backed by manufacturer direct supply
M.A. Ford Cyclone Xd 3X Double Margin Drill
The M.A. Ford CXDSS4375AP is a solid carbide drill with a 7/16 inch diameter built for pneumatic power tools. It targets machinists and maintenance teams who need a 3X diameter drilling depth in a single pass. The double margin design improves hole straightness and surface finish in steel and cast iron. California Proposition 65 warnings apply for cancer and reproductive harm.
Upgrading from single margin or shorter drills
Shops moving from standard single margin drills gain better hole alignment and reduced wandering on deep holes. The jump is worth it when hole tolerance and finish quality outweigh the higher tool cost. It replaces setups that require peck drilling or secondary reaming operations. The 3X length capability reduces cycle time on through holes up to that depth.
Installation and common issues
The drill fits standard 7/16 inch tool holders and collets used in pneumatic drilling machines. No special adapters are required beyond matching the shank to the chuck. Common issues include premature wear if run beyond recommended speeds or without adequate coolant flow. Chip evacuation can become difficult in deep holes if feed rates are not adjusted for the material.
Highlights
- 3X drilling efficiency with Cyclone Xd design
- Solid double margin construction for precise hole accuracy
- 7/16 inch diameter suited for pneumatic applications
- New condition ensures full factory performance
- M.A. Ford quality backed by manufacturer direct supply
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 7/16 Cyclone Xd drill need for a secure fit?
The 7/16 inch drill uses a matching 7/16 inch shank that fits standard three-jaw chucks and collets without an adapter.
How do I install the solid double margin drill correctly and what step is often missed?
Clamp the workpiece, set the pneumatic tool to the recommended speed, apply steady feed pressure and use cutting fluid; the step often missed is lubricating the cutting edges before each hole.
When should the CXDSS4375AP drill be replaced or reconditioned?
Replace or re-sharpen the drill when the double margins show visible wear, chip evacuation slows or hole diameter exceeds tolerance, typically after the number of holes specified in the tool-life chart.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
