M.A. Ford
M.A. Ford CXDSS 1150AP Cyclone Xd 3X Double Margin Drill 11.50 mm
Solid double-margin drill bit cuts precise 11.50 mm holes in demanding materials
- 50 mm diameter drills precise holes
- 3X geometry removes material quickly
- double margin design improves hole straightness
- solid carbide construction resists wear
- new condition ensures full tool life
11.50 mm Cyclone Xd drill
The M.A. Ford CXDSS 1150AP is a 3X double-margin solid drill built for accurate hole-making in demanding materials. Its double-margin design improves hole straightness and surface finish during deep drilling operations. This accessory targets machinists and maintenance technicians who need reliable performance on CNC machines or rigid drill presses.
Step up from standard twist drills
Conventional twist drills tend to wander and wear quickly in tough alloys or deep holes. The Cyclone Xd geometry and double margins maintain alignment and extend tool life where ordinary drills fail. The upgrade pays off when hole tolerance and repeatability are critical to the job.
3X diameter drilling depth
The 3X length-to-diameter ratio provides comfortable reach for holes up to roughly three times the 11.50 mm diameter. Chip evacuation remains manageable within this range without peck cycles. Deeper holes exceed the flute capacity and will require a dedicated deep-hole drill or gun drill instead.
Highlights
- 50 mm diameter drills precise holes
- 3X geometry removes material quickly
- double margin design improves hole straightness
- solid carbide construction resists wear
- new condition ensures full tool life
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 11.50 mm drill need for a secure fit?
The drill has an 11.50 mm diameter; use a collet or chuck that matches this size exactly for proper clamping.
How do you install the double-margin drill without damaging the margins?
Insert the drill fully into the holder before tightening; avoid side-loading the flutes when seating it.
When should the 11.50 mm drill be replaced based on margin wear?
Replace the drill when the double margins show visible rounding or chipping that affects hole finish.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
