M.A. Ford
M.A. Ford CXDSS 1080AP Cyclone Xd 3X Double Margin Drill 10.80mm
Solid double-margin drill creates precise 10.80 mm holes in three-times diameter depth
- 3X drilling depth reaches deeper holes
- Double margin design improves hole straightness
- Cyclone Xd geometry enhances chip evacuation
- 80mm diameter fits precise applications
- California Proposition 65 chemical warning applies
M.A. Ford CXDSS 1080AP Cyclone Xd Drill
The M.A. Ford CXDSS 1080AP is a Cyclone Xd 3X solid double margin drill built for precision holemaking. Its 10.80mm diameter suits metalworking tasks that demand accurate sizing and straightness. The double margin design supports stability during drilling operations. This accessory is sold new for professional and industrial use.
Machinists needing 10.80mm holes
Shops requiring a different diameter, a longer flute length, or a coolant-through design should look at other tooling options. The fixed 10.80mm size does not suit applications needing variable hole sizes or step drilling. Users without rigid toolholding or adequate machine spindle runout control may not achieve the intended precision.
California Proposition 65 chemical notice included
The supplier documentation states this product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. No additional accessories, coatings, or software are bundled with the drill. Safe handling practices and appropriate personal protective equipment are the responsibility of the end user.
Highlights
- 3X drilling depth reaches deeper holes
- Double margin design improves hole straightness
- Cyclone Xd geometry enhances chip evacuation
- 80mm diameter fits precise applications
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What drill chuck size is needed to hold the 10.80 mm shank?
A chuck with a maximum capacity of at least 10.80 mm is required to secure the drill shank.
Will the 10.80 mm diameter work in the same operations as smaller drills I already use?
The larger 10.80 mm diameter removes more material per pass, so feed rates and torque demands will be higher than with smaller drills.
How can I confirm the double-margin design is guiding correctly after setup?
Check that the drilled hole diameter matches 10.80 mm within tolerance and that the wall finish shows consistent, straight lands from both margins.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
