M.A. Ford
M.A. Ford CXDSS 0980AP Cyclone Xd 3X Double Margin Drill 9.80 mm
A 9.80 mm solid carbide drill with double margins for accurate holes in tough materials
- Solid double-margin design improves hole accuracy
- 3X Cyclone Xd geometry increases material removal rate
- 80 mm diameter suits precise drilling tasks
- M.A. Ford manufacturing ensures consistent performance
- California Proposition 65 warning included for safety awareness
Precision 9.80 mm drill bit
The M.A. Ford CXDSS 0980AP Cyclone Xd is a solid carbide drill with a 3× diameter flute length and double-margin geometry. It targets machinists who need accurate hole placement and improved surface finish in a single pass. The 9.80 mm cutting diameter suits metric tap-drill and clearance-hole requirements.
Double-margin stability
Two full-diameter margins guide the tool continuously through the workpiece, reducing walk and chatter on entry and exit. The solid carbide body resists deflection in deep-hole drilling up to three times the diameter. No coolant-through channels are present, so external flood or mist lubrication must be supplied by the machine setup.
California Proposition 65 notice
The product carries a Proposition 65 warning for chemicals known to the State of California to cause cancer and reproductive harm. Buyers who require material-safety documentation or restricted-substance compliance should request the manufacturer’s data sheet before use. No coatings, driver bits or storage case are included with the drill.
Highlights
- Solid double-margin design improves hole accuracy
- 3X Cyclone Xd geometry increases material removal rate
- 80 mm diameter suits precise drilling tasks
- M.A. Ford manufacturing ensures consistent performance
- California Proposition 65 warning included for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What does the 9.80 mm diameter mean for hole size?
The 9.80 mm diameter produces a 9.80 mm hole when used correctly in a rigid setup.
What shank style does the CXDSS 0980AP use for mounting?
The drill uses a straight cylindrical shank that fits standard drill chucks and collets.
How do I install this drill bit without damaging the double margins?
Insert the shank fully into the chuck, tighten evenly, and start at low speed to centre the 9.80 mm tip before increasing feed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
