M.A. Ford
M.A. Ford CXDSS 0530AP Cyclone Xd 5.30 mm pneumatic accessory
A 5.30 mm solid double margin drill bit for precision pneumatic drilling
- Solid double-margin design improves hole accuracy
- 3X construction increases drill rigidity
- 30 mm diameter suits precise drilling tasks
- Cyclone Xd geometry enhances chip evacuation
- New condition ensures full factory performance
M.A. Ford Cyclone Xd 5.30 mm Drill
The M.A. Ford CXDSS 0530AP is a new solid double margin drill designed for pneumatic power tool applications. It features a 3X geometry and a 5.30 mm cutting diameter. This accessory is built for precision drilling tasks in professional workshop environments. The product carries California Proposition 65 warnings regarding chemicals known to cause cancer and reproductive harm.
Suited for precision pneumatic drilling.
This drill suits machinists and technicians who require a 5.30 mm solid double margin tool for pneumatic systems. The 3X design supports accurate holemaking in suitable materials. It is not for operators needing a different cutting diameter or shank configuration. Buyers who want a coated variant or a non-pneumatic shank style should look at something else.
Verify pneumatic compatibility
Before ordering, confirm that your pneumatic tooling accepts the solid double margin shank format. Check that the 5.30 mm diameter matches the hole size required for your specific application. Review the Proposition 65 notices for chemical safety compliance in your workspace. Ensure the 3X geometry aligns with your material and feed parameters.
Highlights
- Solid double-margin design improves hole accuracy
- 3X construction increases drill rigidity
- 30 mm diameter suits precise drilling tasks
- Cyclone Xd geometry enhances chip evacuation
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What pneumatic tool or air compressor is required to run the Cyclone Xd 5.30 mm drill?
The drill is a pneumatic accessory, so it must be connected to a compatible air compressor or pneumatic power tool that supplies the correct pressure and flow for 5.30 mm drilling operations.
Can the 5.30 mm Cyclone Xd drill be used in a standard 3/8 inch or 1/2 inch drill chuck alongside older bits?
The shank on this solid double-margin drill is sized for 5.30 mm, so it will only fit chucks or collets that accept that exact diameter; older imperial chucks will not hold it securely.
How can I confirm the Cyclone Xd 5.30 mm drill is cutting correctly after installation?
When the drill is running, a clean, round hole at 5.30 mm diameter with minimal burr and consistent chip evacuation indicates the double-margin geometry is performing as designed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
