M.A. Ford
M.A. Ford CXDSR1875AP Cyclone Xd 5X Solid Double Margin Drill 3/16 pneumatic accessory
A 3/16-inch Cyclone Xd 5X solid double-margin drill built for pneumatic power tools
- 5x solid double margin design improves hole straightness
- 3/16 inch diameter suits precise drilling tasks
- Cyclone Xd series built for high-speed pneumatic use
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning indicates regulated chemical content
Cyclone Xd 5X Double Margin Drill
The M.A. Ford CXDSR1875AP is a solid double margin drill built for pneumatic power tools. Its 5X geometry supports accurate holemaking in demanding materials. The 3/16 size fits standard tooling setups for professional workshops.
Upgrade from single margin bits
A double margin design improves guidance and finish compared to single margin drills. The step is worthwhile when hole straightness and surface quality are critical. This drill replaces basic bits where precision matters most.
Suited for precision pneumatic drilling
Machinists and fabricators using pneumatic rigs gain tighter tolerances with this tool. It is not for hand drills or low-rigidity setups that cannot hold the 5X geometry. Buyers needing coolant-through capability or larger diameters should look elsewhere.
Highlights
- 5x solid double margin design improves hole straightness
- 3/16 inch diameter suits precise drilling tasks
- Cyclone Xd series built for high-speed pneumatic use
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 warning indicates regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the 3/16 inch Cyclone Xd drill need in a pneumatic chuck?
The 3/16 inch diameter shank fits standard pneumatic drill chucks that accept this size.
How is the solid double margin drill secured in the tool, and what step is often missed?
Tighten the chuck jaws evenly on the 3/16 inch shank; the common mistake is not fully seating the bit before final tightening.
When should the Cyclone Xd 5X drill be replaced due to wear?
Replace the drill when the cutting edges on the 3/16 inch diameter become dull or the double margins show excessive wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
