M.A. Ford
M.A. Ford CXDSR 1470AP Cyclone Xd 5X Double Margin Drill 14.70 mm
Solid double-margin drill creates precise 14.70 mm holes at five times the standard depth
- 5X diameter drilling depth reduces cycle time
- Double margin design improves hole straightness and finish
- 70 mm diameter suits precise hole requirements
- Cyclone Xd geometry enhances chip evacuation
- Solid carbide construction resists wear in tough materials
What it is
This M.A. Ford Cyclone Xd drill is a 14.70 mm solid carbide cutting tool built for 5× diameter hole depths. The double-margin design adds a second land for improved guidance and hole straightness in deep drilling operations. It targets machine shops and maintenance teams that need consistent accuracy without peck cycles.
Sustained-load behaviour
The double-margin geometry stabilises the drill through the full 5× depth, reducing wander and vibration when the flutes are fully engaged. Solid carbide construction maintains edge integrity at higher speeds, while the through-coolant capability — standard on this series — evacuates chips continuously to prevent packing and heat buildup during long, uninterrupted cuts.
Deciding specification
The 14.70 mm diameter is the single figure that determines fit; the tool will not work for holes sized above or below this value. Buyers who need a different diameter, a shorter 3× length, or a replaceable-tip system should select another part number.
Highlights
- 5X diameter drilling depth reduces cycle time
- Double margin design improves hole straightness and finish
- 70 mm diameter suits precise hole requirements
- Cyclone Xd geometry enhances chip evacuation
- Solid carbide construction resists wear in tough materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 14.70 mm drill generate during continuous drilling?
The solid carbide construction and double-margin design help dissipate heat evenly along the cutting edges, reducing localised temperature spikes during extended 5×D drilling cycles.
What tool holder or machine is required to run the CXDSR 1470AP?
A rigid CNC machining centre or high-precision drill press with a 14.70 mm capacity collet or hydraulic chuck is needed; hand-held drills cannot maintain the alignment this geometry demands.
Will this 5×D drill work reliably in a older manual mill with standard run-out?
The double-margin layout improves guidance, but excessive spindle run-out on legacy machines can still cause premature margin wear and hole-quality loss at full 5×D depth.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
