M.A. Ford
M.A. Ford CXDSR 1110AP Cyclone Xd 5X Double Margin Drill 11.10mm
Solid double-margin drill cuts precise 11.10 mm holes with five-times diameter reach
- 5X drilling depth reaches deep holes efficiently
- Double margin design improves hole straightness and finish
- 10 mm diameter suits precise metric drilling
- Cyclone Xd geometry enhances chip evacuation
- Solid carbide construction resists wear in tough materials
11.10 mm 5× solid double-margin drill
The M.A. Ford CXDSR 1110AP Cyclone Xd is a solid carbide drill with a 5× diameter flute length and double-margin guidance. It produces accurate 11.10 mm holes in steel, cast iron and high-temperature alloys. The tool is aimed at machinists and maintenance teams who need repeatable hole quality without peck cycles.
Fits standard tool holders and CNC spindles
The straight shank mounts directly in ER collets, Weldon flats or hydraulic holders with no adapter required. Double margins guide the drill through cross-holes and angled exits, reducing wander and freeing the programmer from adding pilot operations. Internal coolant channels are not present, so external flood or mist coolant must reach the cutting zone.
Replaces single-margin and HSS drills at 11.10 mm
The solid carbide body and double-margin design extend tool life compared with high-speed steel or single-margin carbide drills in abrasive materials. The jump is worthwhile when hole tolerance, surface finish or cycle time justify the higher tool cost. Buyers needing through-coolant delivery or diameters outside 11.10 mm should select a different catalogue item.
Highlights
- 5X drilling depth reaches deep holes efficiently
- Double margin design improves hole straightness and finish
- 10 mm diameter suits precise metric drilling
- Cyclone Xd geometry enhances chip evacuation
- Solid carbide construction resists wear in tough materials
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 11.10 mm Cyclone Xd drill go before chip evacuation becomes the limiting factor?
The 5X solid double-margin design clears chips efficiently in holes up to five times the 11.10 mm diameter, so practical depth is governed by that ratio rather than a fixed millimetre value.
Does the 11.10 mm CXDSR 1110AP run hot or noisy when used continuously in a CNC cycle?
As a solid carbide drill it generates heat at the cutting zone; steady coolant flow and proper feed rates keep temperature and noise at normal machining levels during extended runs.
What tool holder or machine interface is required to run the 11.10 mm Cyclone Xd drill?
The drill uses a standard cylindrical shank sized for the 11.10 mm body, so any ER collet, hydraulic chuck or shrink-fit holder that accepts that shank diameter will secure it.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
