M.A. Ford
M.A. Ford CXDSR 0950AP Cyclone Xd 5X Double Margin Drill 9.50 mm
Solid double-margin drill bit bores 9.50 mm holes with five-times-diameter reach
- Solid double-margin design improves hole accuracy
- 5× diameter drilling depth in a single pass
- 50 mm diameter suits precise metalwork
- Cyclone Xd geometry reduces cutting forces
- California Proposition 65 warning included for safety compliance
Drill for 9.50 mm holes
The M.A. Ford CXDSR 0950AP Cyclone Xd is a solid double margin drill with a 5X diameter-to-length ratio. It is built for production drilling in steel, cast iron and other ferrous materials where hole accuracy and tool life matter. The double margin design guides the drill to improve roundness and surface finish. This item is new and ships directly from the manufacturer.
Behaviour under sustained load
The 5X length-to-diameter ratio provides reach for deeper holes while the double margins reduce vibration during continuous cutting. Chip evacuation remains consistent through the flutes, helping to maintain cutting temperature and dimensional stability over long runs. The solid carbide construction resists wear at the speeds and feeds recommended for this geometry.
Check your setup before ordering
Verify that your machine spindle and holder can accommodate a 9.50 mm shank and the overall length implied by a 5X ratio. Confirm the workpiece material matches the drill’s recommended application range for ferrous metals. Ensure coolant delivery reaches the cutting zone for the depth you intend to drill. This product carries a California Proposition 65 warning for chemicals known to cause cancer and reproductive harm.
Highlights
- Solid double-margin design improves hole accuracy
- 5× diameter drilling depth in a single pass
- 50 mm diameter suits precise metalwork
- Cyclone Xd geometry reduces cutting forces
- California Proposition 65 warning included for safety compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 9.50 mm Cyclone Xd drill generate noticeable heat during extended drilling cycles?
The solid double-margin design improves chip evacuation and hole straightness, which reduces friction and heat buildup during continuous operation.
What tool holder or collet is required to secure the 9.50 mm shank in a CNC machine?
A standard ER collet or hydraulic chuck sized for a 9.50 mm shank will hold the drill securely for high-precision work.
Can the 9.50 mm Cyclone Xd drill be used on a manual mill with a 9.50 mm capacity chuck?
Yes, the 9.50 mm shank fits any chuck or collet that accepts that diameter, allowing use on older manual or CNC machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
