M.A. Ford
M.A. Ford CXDSR 0720AP Cyclone Xd 5X Solid Double Margin Drill 7.20mm pneumatic accessory
A solid double-margin drill bit with 5x diameter depth capacity for precise 7.20mm pneumatic drilling
- 5x diameter reach for deeper holes
- 20 mm diameter fits precise drilling tasks
- double margin design improves hole straightness
- solid carbide construction resists wear longer
- Cyclone Xd geometry optimises chip evacuation
7.20 mm Cyclone Xd Drill
The M.A. Ford CXDSR 0720AP is a 5X solid double-margin drill designed for pneumatic drilling systems. It targets machinists and maintenance teams who need accurate hole-making in ferrous and non-ferrous metals. The 7.20 mm diameter suits standard tapping and clearance operations in automotive and general fabrication shops. This accessory ships new and carries a California Proposition 65 warning for listed chemicals.
Fits pneumatic drill motors
The straight-shank tool mounts directly into compatible pneumatic drill motors or quick-change adapters without extra bushings. Its double-margin geometry guides the drill in the hole, reducing the need for external piloting fixtures. The solid-carbide construction eliminates the brazed-joint failure point found on tipped drills, freeing the operator from frequent tool changes on abrasive alloys. No coolant-through channels are present, so external flood or mist lubrication must be supplied by the machine.
Holds size under sustained load
The solid carbide body and 5X flute length dissipate heat evenly during extended drilling cycles, keeping diameter deviation low compared with tipped equivalents. Double margins maintain alignment when the drill engages cross-holes or interrupted cuts, preventing walk that would otherwise widen the hole. The design resists chipping at the margin edges when feed rates are held steady, so hole quality remains consistent through long production runs. California Proposition 65 warnings apply to dust generated during prolonged use.
Highlights
- 5x diameter reach for deeper holes
- 20 mm diameter fits precise drilling tasks
- double margin design improves hole straightness
- solid carbide construction resists wear longer
- Cyclone Xd geometry optimises chip evacuation
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 7.20 mm Cyclone Xd 5X drill go before chip evacuation becomes the limiting factor?
The 5X solid double-margin design evacuates chips efficiently, so depth is limited by the 7.20 mm flute length and your machine spindle travel rather than clogging.
Does the 7.20 mm drill generate noticeable heat or vibration during continuous pneumatic operation?
The double-margin geometry stabilises the cut, reducing vibration and heat build-up during extended pneumatic drilling cycles.
What shank style or holder is required to run the 7.20 mm Cyclone Xd drill in my pneumatic tool?
The drill uses a standard straight shank that fits common pneumatic drill chucks or collets sized for 7.20 mm tooling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
