M.A. Ford
M.A. Ford CXDCS 1010AP Cyclone Xd 10.10 mm drill
A 10.10 mm coolant-fed double-margin drill for high-performance drilling
- Precision drilling with 10.10 mm diameter
- Coolant-fed design enables efficient heat management
- Double margin construction improves hole accuracy
- Cyclone Xd series built for demanding applications
- New condition ensures full factory performance
Precision drilling with 10.10 mm diameter
This 10.10 mm Cyclone Xd drill is built for machinists who need a coolant-fed, double-margin tool for accurate hole-making. It suits production environments where consistent chip evacuation and hole straightness are critical. The new condition ensures full tool life from the first use.
Coolant-fed design removes heat at the cutting zone
Internal coolant channels deliver fluid directly to the drill point, reducing the need for external flood coolant and freeing up machine enclosure space. The double-margin construction guides the drill without a separate pilot hole, simplifying the setup for through-hole applications.
Sustained cutting relies on continuous coolant flow
Under prolonged drilling cycles the 3X coolant-fed geometry maintains stable temperatures at the cutting edges, preventing thermal degradation that shortens tool life in high-volume runs. Without adequate coolant pressure the drill cannot sustain its designed performance.
Highlights
- Precision drilling with 10.10 mm diameter
- Coolant-fed design enables efficient heat management
- Double margin construction improves hole accuracy
- Cyclone Xd series built for demanding applications
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 10.10 mm Cyclone Xd drill before chip evacuation becomes the limiting factor?
The 3× coolant-fed design with double margins pushes chips out continuously, so the practical limit is the machine’s spindle travel rather than the drill’s own flute length.
What temperature does the shank reach during an all-day production run in alloy steel?
Through-tool coolant keeps the cutting zone near ambient temperature, so the shank stays cool enough for continuous operation without forced-air pauses.
Which tool-holding system is required for the CXDCS 1010AP’s shank?
A standard hydraulic or shrink-fit holder that accepts a 10.10 mm cylindrical shank is all that is needed; no proprietary adapter is required.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
