M.A. Ford
M.A. Ford CXDCR 1500AP Cyclone Xd 5X Double Margin Drill 15.00 mm
Coolant-fed double-margin drill delivers 5× diameter depth at 15.00 mm
- 5X drill depth enables deeper holes in one pass
- Double margin design improves hole straightness and finish
- Coolant-fed construction extends tool life in tough materials
- 00 mm diameter suits precise machining applications
- California Proposition 65 warning indicates chemical safety awareness
15.00 mm Cyclone Xd 5X drill for precision holes
The M.A. Ford CXDCR 1500AP is a 15.00 mm coolant-fed drill with a double-margin design. It targets machinists and fabricators who need accurate, repeatable holes in demanding materials. The 5X diameter capability supports deeper drilling cycles without frequent pecking. This tool suits CNC and high-pressure coolant setups where chip evacuation and hole straightness are critical.
Coolant-fed thermals and cutting stability
Internal coolant delivery manages heat at the cutting zone during extended 5X depth passes. The double-margin geometry improves guidance, reducing vibration and the power spikes that come from wandering. Steady torque draw follows from consistent chip formation rather than intermittent loading. Operators see less thermal drift on the workpiece and quieter cutting compared with external flood-only arrangements.
Replaces single-margin
Shops moving from conventional twist drills or single-margin tools gain the jump when hole depth exceeds 3X diameter or when tolerance stacks demand better straightness. The upgrade pays off in reduced cycle time and fewer secondary reaming operations. It is not for hand-held use, low-pressure coolant systems, or diameters outside the 15.00 mm specification.
Highlights
- 5X drill depth enables deeper holes in one pass
- Double margin design improves hole straightness and finish
- Coolant-fed construction extends tool life in tough materials
- 00 mm diameter suits precise machining applications
- California Proposition 65 warning indicates chemical safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 15.00 mm Cyclone Xd drill in a coolant-fed holder, and what step is often missed?
Mount the shank fully into the tool holder, engage the coolant feed, and verify flow before cutting — skipping the flow check is the common error.
What maintenance or replacement will the 1500AP drill need later?
Replace the drill when the 15.00 mm margins show flank wear; clean the internal coolant passages after every use to prevent blockage.
What limit appears first during sustained drilling with this 15.00 mm tool?
Margin wear on the 15.00 mm diameter typically limits tool life before the coolant-fed design reaches thermal limits.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
