M.A. Ford
M.A. Ford CXDCR 0540AP Cyclone Xd 5.40 mm Coolant-Fed Double Margin Drill
A 5.40 mm coolant-fed double-margin drill for precise deep-hole drilling
- Precise 5.40 mm diameter for accurate holes
- Coolant-fed design improves chip evacuation and tool life
- Double-margin geometry enhances hole straightness and finish
- Cyclone Xd series built for high-performance drilling
- New condition ensures full factory performance
M.A. Ford Cyclone Xd 5.40 mm Drill
The M.A. Ford Cyclone Xd 5.40 mm Coolant-Fed Double Margin Drill is a precision cutting tool designed for machining operations requiring accurate hole placement. It suits manufacturers and machinists who need reliable performance in CNC applications. The double margin design improves hole straightness and surface finish during drilling cycles.
Sustained Load Performance
Coolant-fed delivery channels fluid directly to the cutting zone, maintaining thermal stability during extended production runs. The 5X diameter capability supports deeper holes without Peck cycles, reducing cycle time under continuous load. Double margins guide the tool consistently, preventing drift when cutting tough alloys or stacked materials.
Installation and Common Issues
The straight shank fits standard ER collets, hydraulic holders, and shrink-fit systems for secure clamping. Incorrect coolant pressure or filtration allows chips to pack the flutes, causing premature wear or breakage. Running without through-spindle coolant defeats the design intent and leads to overheating in deep-hole applications. California Proposition 65 warnings apply to this product.
Highlights
- Precise 5.40 mm diameter for accurate holes
- Coolant-fed design improves chip evacuation and tool life
- Double-margin geometry enhances hole straightness and finish
- Cyclone Xd series built for high-performance drilling
- New condition ensures full factory performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 5.40 mm Cyclone Xd drill run hot or make much noise during extended use?
The drill is a solid carbide cutting tool without a motor, so heat and noise depend entirely on the machine spindle, coolant flow and workpiece material rather than the drill itself.
What toolholder or machine interface is needed to run this 5.40 mm coolant-fed drill?
A compatible coolant-through holder such as a hydraulic chuck, shrink-fit holder or ER collet with sealed nut is required, matched to your machine spindle taper and capable of delivering coolant through the tool.
Can the 5.40 mm double-margin drill be used in an older CNC that only has external flood coolant?
Internal coolant passages need through-spindle or through-holder delivery; without that capability the drill cannot receive coolant at the cutting edges, so performance and tool life will be reduced.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
