M.A. Ford
M.A. Ford CXDCR 0530AP Cyclone XD 5X Double Margin Drill 5.30 mm
A 5.30 mm double-margin drill with internal coolant feed for 5× diameter depth
- 5x diameter reach for deeper holes
- Coolant-fed design clears chips efficiently
- Double margins improve hole accuracy
- 30 mm cutting diameter fits precise bores
- California Prop 65 warning included
5.30 mm Cyclone XD 5X Drill
The M.A. Ford CXDCR 0530AP is a solid-carbide drill with a 5X diameter-to-depth ratio and double-margin geometry. Internal coolant channels deliver cutting fluid directly to the tip for chip evacuation and temperature control. It is designed for CNC machining of steels, stainless steels and high-temperature alloys where hole accuracy and tool life are critical.
Coolant-fed double-margin design
Through-spindle coolant capability is required to use the internal channels; the drill will not perform as intended with external flood coolant alone. The double margins guide the tool in the hole, improving straightness and surface finish while reducing the need for a separate reaming operation. A rigid tool holder and stable work holding are necessary to maintain the tight tolerances this geometry provides.
Sustained high-feed drilling
Continuous coolant flow prevents thermal buildup during deep-hole cycles, allowing consistent feed rates without the dwell periods required by non-coolant-fed tools. The double margins maintain alignment as the drill reaches full 5X depth, limiting drift that would otherwise scrap the part. California Proposition 65 warnings apply: the product contains chemicals known to the state to cause cancer and reproductive harm.
Highlights
- 5x diameter reach for deeper holes
- Coolant-fed design clears chips efficiently
- Double margins improve hole accuracy
- 30 mm cutting diameter fits precise bores
- California Prop 65 warning included
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 5.30 mm Cyclone XD drill cut before chip evacuation becomes the limiting factor?
The 5X diameter design supports a maximum drilling depth of roughly five times the 5.30 mm diameter, so chip removal is the first constraint on deeper holes.
How much heat does the double-margin 5.30 mm drill generate during continuous high-speed operation?
Coolant-fed channels run through the tool body, directing fluid to the cutting zone to control temperature during extended runs.
What machine setup is required to run the coolant-fed 5.30 mm Cyclone XD drill?
A spindle with through-coolant capability and a compatible coolant delivery system are needed to supply fluid through the drill.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
