M.A. Ford
M.A. Ford CXDCL2812AP Cyclone XD 8X coolant-fed drill 9/32 7.14M
Coolant-fed double-margin drill with 8× diameter reach for 9/32 inch and 7.14 mm holes
- 8× diameter reach for deep-hole drilling
- Coolant-fed design clears chips from the cut
- Double-margin construction keeps the drill running true
- 9/32 in / 7.14 mm diameter fits the application
- California Prop 65 notice included for compliance
Drill for deep-hole coolant applications
The M.A. Ford CXDCL2812AP Cyclone XD 8X is a coolant-fed double-margin drill built for high-penetration drilling in demanding materials. Its 8X diameter-to-length capability suits production shops that need reliable deep-hole performance without peck cycles. The tool targets machinists running CNC centres with through-spindle coolant.
Replaces standard twist drills in deep holes
Conventional drills tend to wander or overheat past 3X to 5X diameter, forcing frequent retracts that slow cycle time. This drill’s double-margin design and internal coolant delivery maintain straightness and chip evacuation at 8X, so the upgrade pays off when hole depth exceeds the reach of standard tooling. Shops drilling shallower holes will not see the same gain.
Holds size and finish under continuous cutting
Through-tool coolant flushes chips from the flutes while the twin margins guide the drill, keeping diameter tolerance and surface finish stable during long, uninterrupted cuts. Heat stays controlled at the point of cut, reducing the risk of thermal expansion or premature wear. The design is not intended for intermittent hand-held use or machines without coolant pressure.
Highlights
- 8× diameter reach for deep-hole drilling
- Coolant-fed design clears chips from the cut
- Double-margin construction keeps the drill running true
- 9/32 in / 7.14 mm diameter fits the application
- California Prop 65 notice included for compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What spindle or holder accepts the 9/32 inch shank on this Cyclone XD drill?
The drill has a 9/32 inch shank that fits standard drill chucks or collets sized for that diameter.
How do I connect coolant to the through-tool channels on this double-margin drill?
Supply coolant through the machine spindle directly into the drill's internal coolant holes; ensure the coolant port aligns before tightening.
When should the CXDCL2812AP be replaced based on wear?
Replace when the double margins show uneven wear, the 7.14 mm cutting diameter falls below tolerance, or coolant flow drops due to internal blockage.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
