M.A. Ford
M.A. Ford CDACRM1140 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A coolant-fed cyclone drill for aluminium with two flutes, 5X reach and model CDACRM1140
- Designed for aluminium machining with 5× diameter reach
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford Cyclone series built for high-speed drilling
- California Proposition 65 warning applies to this product
M.A. Ford CDACRM1140 Cyclone Drill
This drill is built for aluminium machining with a 5X diameter design and two-flute geometry. Internal coolant channels deliver fluid directly to the cutting zone. It suits CNC operators and job-shop machinists who need reliable chip evacuation in non-ferrous materials.
Sustained cutting in aluminium
The coolant-fed design maintains consistent temperatures during extended drilling cycles. Two flutes provide a clear path for chips to exit the hole without packing. This reduces the risk of built-up edge and helps hold dimensional accuracy over long production runs.
Standard shank fit and coolant setup
The tool installs in any compatible holder that matches its shank specification. A machine with through-spindle or flood coolant capability is required to use the internal channels. Without adequate coolant pressure the drill cannot clear chips effectively and may overheat.
Highlights
- Designed for aluminium machining with 5× diameter reach
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford Cyclone series built for high-speed drilling
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 5× length of the CDACRM1140 Cyclone drill generate more heat during extended runs in aluminium?
The 5× flute design evacuates chips efficiently with coolant feed, reducing heat build-up during long drilling cycles.
What machine setup is required to use the coolant-fed feature on this drill?
A CNC or milling centre with through-spindle coolant delivery is needed to supply fluid through the drill’s internal channels.
Can the CDACRM1140 be used in older manual drill presses without coolant?
It will cut without coolant, but the 5× design performs best with flood or through-tool coolant to clear chips from deep holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
