M.A. Ford
M.A. Ford CDACRM0670 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
Coolant-fed cyclone drill with two flutes for aluminium at five times the speed
- Designed for aluminium with 5× diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M. A. Ford brand backs professional-grade tooling
- California Proposition 65 warning applies to this product
Cyclone Drill for Aluminium
The M.A. Ford CDACRM0670 Cyclone Drill is engineered specifically for aluminium machining. Its 5x diameter flute length and two-flute geometry provide effective chip evacuation in non-ferrous materials. The coolant-fed design delivers lubricant directly to the cutting zone. This tool targets CNC operators and job shops producing aluminium components.
670 flute length and coolant feed
The 670 flute length offers extended reach for deeper holes without peck cycles. Coolant-through capability reduces built-up edge and improves surface finish in soft alloys. Two flutes balance chip space with core strength for stable drilling. The design reaches its limit in abrasive or high-silicon aluminium grades where specialised coatings become necessary.
Coolant-fed shank changes workflow
The internal coolant channel eliminates the need for external flood coolant aiming at the drill point. This reduces setup time and keeps chips clear in blind-hole applications. Operators gain consistent hole quality on unattended runs. The shank requires a compatible tool holder with through-coolant sealing to function.
Highlights
- Designed for aluminium with 5× diameter reach
- Two-flute geometry clears chips efficiently in soft metal
- Coolant-fed design delivers fluid to the cutting zone
- M. A. Ford brand backs professional-grade tooling
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 670 mm flute length reach through the same aluminium stock I drill with my older 3X tool?
The 5X flute depth on this drill extends further than a typical 3X tool, so it can complete deeper holes in a single pass without pecking.
How do I confirm coolant is flowing correctly through the internal channels after I mount the drill?
Start the machine at low speed and watch for a steady stream exiting the tip; consistent flow means the internal passages are clear and the seal is holding.
Does the box include the coolant‑fed holder or just the 2‑flute drill body?
Only the Cyclone drill body is supplied; a compatible coolant‑fed holder or collet must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
