M.A. Ford
M.A. Ford CDACRM0570 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
A 5× diameter cyclone drill with two flutes and coolant feed for aluminium
- Designed for aluminium machining with 5X flute geometry
- Two-flute configuration enhances chip evacuation in soft alloys
- Internal coolant feed improves tool life and surface finish
- Cyclone series engineering targets high-speed drilling applications
- California Proposition 65 warning applies to this product
Cyclone Drill for Aluminium 5X
The M.A. Ford CDACRM0570 Cyclone Drill is engineered specifically for aluminium machining with a 5X diameter design. Its two-flute geometry and internal coolant feed target chip evacuation and heat control in non-ferrous materials. This tool serves CNC operators and job shops that need reliable holemaking in aluminium alloys.
Coolant-fed installation and common issues
The drill fits standard holders that accept through-coolant supply; no special adapters are required beyond a compatible machine spindle. Problems usually arise when coolant pressure is too low to clear chips from deep holes or when the holder runout exceeds the tight tolerance needed for the 5X length. Dry running or misaligned fixtures will degrade tool life quickly.
Machine and setup checks before ordering
Verify that your machine can deliver sustained coolant flow through the spindle at the pressure your aluminium grade demands. Confirm the tool holder provides the concentricity required for a 5X flute length without additional support. Ensure the workpiece clamping prevents vibration, as the extended reach amplifies any movement. The product carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm.
Highlights
- Designed for aluminium machining with 5X flute geometry
- Two-flute configuration enhances chip evacuation in soft alloys
- Internal coolant feed improves tool life and surface finish
- Cyclone series engineering targets high-speed drilling applications
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I confirm the CDACRM0570 is cutting correctly after installation?
The drill should produce smooth holes in aluminum with consistent chip evacuation through the coolant-fed channels when running at proper speeds.
What comes with the CDACRM0570 and what must I supply?
The package contains the Cyclone drill bit only; you must provide the coolant system, tool holder and compatible machine spindle separately.
Which version of the Cyclone drill should I choose for 5× diameter depth in aluminum?
The CDACRM0570 is the 5× 2-flute coolant-fed model designed for that depth-to-diameter ratio in aluminum.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
