M.A. Ford
M.A. Ford CDACRM0520 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
Cyclone drill for aluminium with 5× diameter reach, two flutes and coolant-fed design
- Designed for aluminium machining with 5x diameter reach
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design directs fluid to the cutting zone
- M.A. Ford quality backed by decades of tooling expertise
- California Proposition 65 warning applies to this product
M.A. Ford Cyclone Drill for Aluminium
The M.A. Ford CDACRM0520 Cyclone Drill is a new cutting tool designed for aluminium work. It features a 5X diameter drilling depth and a two-flute geometry with internal coolant delivery. This specification targets efficient chip evacuation and heat management in non-ferrous materials.
Suited for aluminium drilling with coolant systems
Machinists running CNC centres with through-spindle coolant will benefit from the 5X reach and flute design optimised for aluminium. Shops without coolant capability or those drilling steel, titanium or hardened alloys should look at different tooling because this drill is specialised for non-ferrous applications.
Coolant-fed design changes chip control
The internal coolant channels push fluid directly to the cutting edges, improving chip breaking and evacuation in deep aluminium holes. This reduces the risk of built-up edge and allows consistent performance at the 5X depth without peck cycles. The Prop 65 notice indicates chemical content requiring workplace awareness.
Highlights
- Designed for aluminium machining with 5x diameter reach
- Two-flute geometry improves chip evacuation in soft alloys
- Coolant-fed design directs fluid to the cutting zone
- M.A. Ford quality backed by decades of tooling expertise
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What machine spindle and coolant system are needed to run the CDACRM0520?
The CDACRM0520 requires a machine spindle that accepts its shank and a through-spindle coolant system to deliver fluid to the drill point.
Can the 5X 2 flute design work with standard aluminium fixtures?
The 5X length and two-flute geometry suit deep-hole drilling in aluminium using conventional work-holding.
How do I verify the CDACRM0520 is cutting correctly after setup?
Check for smooth chip evacuation through the flutes, steady coolant flow at the tip and consistent hole diameter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
