M.A. Ford
M.A. Ford CDACRM0450 Cyclone Aluminum Drill 5X 2 Flute Coolant Fed
Coolant-fed drill with two flutes for aluminium, 5× diameter depth capability
- Designed for aluminium with 5X diameter drilling depth
- Two-flute geometry improves chip evacuation in soft metals
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford manufacturing ensures consistent tool quality
- California Proposition 65 warning applies to this product
Aluminium drill for production runs
The M.A. Ford CDACRM0450 Cyclone is a dedicated aluminium drill built for five-times-diameter depth in a single pass. Its two-flute geometry and through-coolant feed evacuate chips efficiently, making it suited to CNC cells and high-volume workstations where cycle time matters. The tool arrives new and ships directly from the manufacturer.
Coolant-fed shank fits standard holders
The coolant-fed shank connects to existing through-spindle or external supply systems without adapter sleeves, freeing the turret from secondary drilling operations. No special holder is required beyond a standard ER or hydraulic chuck that accepts the shank diameter, so the drill slots into current aluminium programmes with minimal setup change.
Proposition 65 notice applies
California Proposition 65 warnings indicate the presence of chemicals known to cause cancer and reproductive harm, so operators should follow shop safety protocols and wear appropriate PPE. Normal cutting loads produce manageable heat when coolant flow is maintained, and the two-flute design limits vibration that can amplify noise in thin-wall aluminium parts.
Highlights
- Designed for aluminium with 5X diameter drilling depth
- Two-flute geometry improves chip evacuation in soft metals
- Coolant-fed design delivers fluid directly to the cutting zone
- M.A. Ford manufacturing ensures consistent tool quality
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How deep can the 5X drill go before chip evacuation becomes the limiting factor?
The 5X length-to-diameter ratio allows drilling up to five times the drill diameter before flute capacity limits chip removal in aluminium.
Does the coolant-fed design keep the tip cool enough for continuous production runs?
Internal coolant delivery targets the cutting edges directly, reducing heat build-up during extended drilling cycles in aluminium.
What machine spindle interface is required to run this coolant-fed drill?
A spindle with through-coolant capability and a holder matching the drill shank is needed to supply coolant through the tool.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
