M.A. Ford
M.A. Ford CDACR4375 Cyclone Drill Aluminum 5X 2 Flute Coolant Fed
Cyclone drill for aluminium with two flutes, 5× diameter reach and through-coolant feed
- Optimised flute geometry clears chips efficiently in aluminium
- Coolant-fed design delivers fluid directly to the cutting zone
- Five-times diameter reach enables deep-hole drilling
- Two-flute construction balances strength and chip evacuation
- M.A. Ford manufacturing ensures consistent tool performance
Cyclone Drill For Aluminum 5X 2 Flute
The M.A. Ford CDACR4375 is a new Cyclone drill designed for aluminium work. Its 5X diameter reach and two-flute geometry target high-speed material removal in non-ferrous metals. Coolant-fed operation supports consistent chip evacuation during deep-hole cycles. Machinists running CNC or dedicated drill presses gain a tool built for aluminium-specific chip formation.
Replaces Conventional Twist Drills In Aluminium
Standard twist drills often pack flutes or overheat when pushed to 5X depth in soft alloys. This design upgrades from that limitation with polished flutes and through-coolant delivery that clears chips at the source. The jump is worth it when cycle time drops because peck drilling is reduced or eliminated. Shops drilling shallow holes in steel or cast iron will not see the same benefit.
Handles Deep Aluminium Holes At Production Speeds
The tool comfortably handles 5X diameter holes in aluminium alloys with coolant pressure doing the heavy lifting on evacuation. It runs out of headroom when material hardness rises above the design envelope or when coolant supply is interrupted. Without through-spindle coolant the flutes can load up quickly. Buyers needing carbide grades for abrasive composites or high-temp alloys should look elsewhere.
Highlights
- Optimised flute geometry clears chips efficiently in aluminium
- Coolant-fed design delivers fluid directly to the cutting zone
- Five-times diameter reach enables deep-hole drilling
- Two-flute construction balances strength and chip evacuation
- M.A. Ford manufacturing ensures consistent tool performance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank diameter does the CDACR4375 Cyclone Drill need to fit my tool holder?
The CDACR4375 Cyclone Drill uses a standard shank that fits common 1/2 inch drill chucks and CNC tool holders for coolant-fed operation.
How do I install the CDACR4375 Cyclone Drill so coolant flows correctly through the flutes?
Insert the drill fully into the holder, align the coolant port with the machine's through-spindle supply, and tighten securely; the step often missed is verifying coolant exits at the tip before cutting.
When should I replace the CDACR4375 Cyclone Drill based on wear or Prop 65 handling?
Replace the drill when the 2 flute cutting edges show chipping or diameter loss; always wear gloves and wash hands after handling due to California Proposition 65 listed chemicals.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
