M.A. Ford
M.A. Ford 30625000 Twister Circuit Board Drill 1/4- E & 6
Large circuit board drill with Twister geometry for precision holes in electronic materials
- Twister drill designed for circuit board precision
- 1/4- E & 6 sizing for specialised drilling tasks
- M.A. Ford brand trusted in power tool accessories
- New condition ready for immediate workshop use
- California Proposition 65 chemical warning applies
Twister Circuit Board Drill 30625000
The M.A. Ford 30625000 Twister is a large-size circuit board drill built for professional PCB fabrication and repair work. It targets technicians who need reliable hole-making in composite board materials.
Sustained drilling behaviour
The Twister design resists heat build-up during extended drilling cycles, keeping cutting edges stable when producing multiple holes in succession. This reduces wander and maintains hole accuracy across a full production run without frequent tool changes.
Installation notes
The drill uses a standard 1/4 inch shank that fits common collets and quick-change chucks on CNC routers and precision hand drills. Ensure the collet is clean and fully seated; a loose grip causes run-out that snaps the carbide tip on the first plunge.
Warning label requirements
California Proposition 65 notices state this product contains chemicals known to cause cancer and birth defects or other reproductive harm. Handle with appropriate protective equipment and dispose of worn drills according to local hazardous-waste regulations.
Highlights
- Twister drill designed for circuit board precision
- 1/4- E & 6 sizing for specialised drilling tasks
- M.A. Ford brand trusted in power tool accessories
- New condition ready for immediate workshop use
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the Twister 30625000 drill generate noticeable heat during continuous circuit-board drilling?
The drill is designed for circuit-board work and does not produce excessive heat under normal use.
What collet or chuck size is required to hold the 1/4-inch shank of the 30625000?
A 1/4-inch capacity collet or drill chuck is needed to secure the shank.
Can the 30625000 be used with an older variable-speed drill press without damaging the bit?
Yes, it works with standard drill presses when run at appropriate speeds for circuit-board material.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
