M.A. Ford
M.A. Ford 305M0087 Twister Micro-Tuff Drill 0.87Mm pneumatic accessory
Twister Micro-Tuff drill bit with 0.87 mm diameter for precision pneumatic drilling
- Twister Micro-Tuff drill for precision micro-drilling
- 87 mm diameter suits fine-hole applications
- M.A. Ford brand trusted in power tool accessories
- New condition ensures full factory performance
- California Proposition 65 notice included for chemical awareness
Precision micro drilling
The M.A. Ford 305M0087 Twister Micro-Tuff Drill is a pneumatic accessory manufactured to a 0.87 mm diameter for fine-hole applications. It serves technicians and engineers who require accurate small-diameter drilling in metals and composites. The tool is supplied new and carries California Proposition 65 notices for cancer and reproductive-harm chemicals.
Pneumatic integration
The drill installs directly into a compatible pneumatic handpiece or spindle, drawing compressed air rather than electricity. This arrangement removes the need for an electric motor at the point of use and reduces heat transfer to delicate workpieces. No free-shipping threshold or direct-from-manufacturer logistics affect the mechanical interface.
Sustained cutting behaviour
Under continuous operation the Micro-Tuff geometry maintains chip evacuation and edge integrity at the stated diameter. The design resists deflection during extended cycles, allowing consistent hole quality without frequent tool changes. California Proposition 65 warnings remain applicable regardless of duty cycle.
Highlights
- Twister Micro-Tuff drill for precision micro-drilling
- 87 mm diameter suits fine-hole applications
- M.A. Ford brand trusted in power tool accessories
- New condition ensures full factory performance
- California Proposition 65 notice included for chemical awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How small a hole can the 0.87 mm Twister Micro-Tuff Drill produce before the bit walks or breaks?
The 0.87 mm diameter is the cutting size; the micro-grain carbide and reinforced web resist deflection so the bit starts on centre and holds size in hardened steels and exotic alloys.
Does the drill generate noticeable heat or vibration during extended runs in a pneumatic handpiece?
The polished flute geometry evacuates chips cleanly, reducing friction and heat build-up, while the stub-length design keeps vibration low during continuous high-speed air-tool use.
What shank style does the 305M0087 use so I can match it to my existing collet or chuck?
The drill has a plain cylindrical shank sized to the nominal 0.87 mm diameter, fitting standard micro-collets and pin-chucks used on precision pneumatic spindles.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
