M.A. Ford
M.A. Ford 305M0053 Twister Micro-Tuff Drill 0.53mm pneumatic accessory
A 0.53 mm Twister Micro-Tuff drill bit for precision pneumatic drilling tasks
- Twister Micro-Tuff geometry drills precise 0.53 mm holes
- M.A. Ford manufacture delivers professional-grade cutting performance
- Pneumatic accessory fits standard air-tool setups
- Brand-new condition ensures full tool life from first use
- Prop 65 notice flags regulated chemical content for safety awareness
Micro-Tuff Drill 0.53mm
The M.A. Ford Twister Micro-Tuff Drill is a 0.53mm pneumatic accessory designed for precision drilling tasks. It suits machinists and technicians who need a small-diameter cutting tool for detailed work in metal or composite materials. The drill is supplied new and ready for use in compatible pneumatic systems.
Sustained load behaviour
The Micro-Tuff construction resists wear during extended drilling cycles, maintaining cutting geometry under continuous pneumatic power. Heat buildup is managed by the tool design so the 0.53mm diameter stays consistent throughout long production runs. Operators can rely on steady material removal without frequent tool changes.
Deciding specification
The 0.53mm diameter is the single figure that determines fit for the application; holes larger or smaller than this size require a different drill. Buyers who need a different bore size cannot use this accessory. California Proposition 65 warnings also apply to this product.
Highlights
- Twister Micro-Tuff geometry drills precise 0.53 mm holes
- M.A. Ford manufacture delivers professional-grade cutting performance
- Pneumatic accessory fits standard air-tool setups
- Brand-new condition ensures full tool life from first use
- Prop 65 notice flags regulated chemical content for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 0.53 mm Twister Micro-Tuff drill generate during continuous pneumatic use?
The drill itself produces negligible heat; any warmth comes from air-motor friction and the workpiece, not from the accessory.
What pneumatic fittings and air supply must I already have to run this 0.53 mm drill?
You need a compatible collet or chuck for 0.53 mm shanks and a regulated air line delivering the pressure your air motor specifies.
Will the 0.53 mm Twister Micro-Tuff drill fit the collet on my older micro air motor?
It fits any collet or chuck that accepts a 0.53 mm shank; verify your motor's collet size before ordering.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
