M.A. Ford
M.A. Ford 305M0040AM Twister Micro-Tuff Drill 0.40 mm pneumatic accessory
A 0.40 mm Twister Micro-Tuff drill bit for precision pneumatic drilling applications
- Micro-Tuff coating extends tool life in abrasive materials
- 40 mm diameter enables precise micro-hole drilling
- Twister flute geometry improves chip evacuation at high speed
- California Proposition 65 warning discloses regulated chemical content
- M.A. Ford brand backs professional-grade pneumatic accessory quality
Precision Micro Drilling
The M.A. Ford 305M0040AM Twister Micro-Tuff Drill is a 0.40 mm pneumatic accessory built for high-precision hole making. It targets machinists and technicians who need reliable performance in tight-tolerance applications. The solid carbide construction supports accurate results in demanding materials.
Suitability For Fine Hole Work
This drill suits operators producing micro-diameter holes in metals or composites where standard twist drills cannot reach. It is not for buyers who need larger diameters, coolant-through capability, or indexable insert tooling. The specialised geometry limits use to very small hole requirements.
Critical Diameter Specification
The 0.40 mm cutting diameter is the single figure that determines if this tool fits the job. A hole specification even slightly above or below this size makes the drill unsuitable. Verify the exact target diameter before ordering this specific accessory.
Highlights
- Micro-Tuff coating extends tool life in abrasive materials
- 40 mm diameter enables precise micro-hole drilling
- Twister flute geometry improves chip evacuation at high speed
- California Proposition 65 warning discloses regulated chemical content
- M.A. Ford brand backs professional-grade pneumatic accessory quality
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How small a hole can the 0.40 mm Twister Micro-Tuff Drill produce before the bit reaches its limit under sustained use?
The 0.40 mm diameter is the smallest cutting size this drill offers; pushing it further would exceed the tool's design envelope.
What heat or vibration level should I expect when running the Twister Micro-Tuff Drill continuously in a pneumatic tool?
The micro-diameter geometry reduces cutting forces, so heat build-up and vibration stay low even during extended drilling cycles.
Which pneumatic tool holder or collet do I need to fit the 0.40 mm shank of this Twister Micro-Tuff Drill?
A precision collet or chuck that accepts a 0.40 mm shank is required; standard 1/4 in or 3 mm holders will not grip it securely.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
