M.A. Ford
M.A. Ford 305M0030AM Twister Micro-Tuff Drill 0.30 mm pneumatic accessory
Twister Micro-Tuff drill bit creates 0.30 mm holes in demanding materials
- 30 mm Micro-Tuff drill for precise micro-hole drilling
- Twister flute geometry enhances chip evacuation in tight spaces
- M.A. Ford quality construction delivers reliable performance
- Designed for pneumatic power tool compatibility
- California Prop 65 warning applies to this product
Micro-Tuff Drill for precision work
The M.A. Ford 305M0030AM Twister Micro-Tuff Drill is a pneumatic accessory with a 0.30 mm diameter. It is manufactured for detailed drilling tasks that require a very fine cutting tool. This new item suits professionals and hobbyists working on small-scale components or intricate assemblies.
Consistent cutting under extended use
The Micro-Tuff construction supports sustained operation in pneumatic tools without rapid wear. It maintains its geometry during repetitive cycles where standard drills might deflect or overheat. Buyers needing high feed rates or deep holes in tough alloys should verify capability separately.
0.30 mm diameter defines the application
The 0.30 mm size is the single specification that determines fit for the job. It suits only tasks matching this exact bore requirement. Workshops needing larger diameters or different shank styles must select another tool.
Highlights
- 30 mm Micro-Tuff drill for precise micro-hole drilling
- Twister flute geometry enhances chip evacuation in tight spaces
- M.A. Ford quality construction delivers reliable performance
- Designed for pneumatic power tool compatibility
- California Prop 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much vibration or heat does the 0.30 mm drill produce during continuous pneumatic use?
The 0.30 mm Twister Micro-Tuff drill is designed for high-speed pneumatic operation; vibration and heat depend on the air supply pressure and the material being drilled.
What pneumatic fittings or collet size must I already have to run this 0.30 mm drill?
The drill has a 0.30 mm cutting diameter; it requires a compatible pneumatic handpiece or collet that accepts this shank size and a regulated air supply.
Will the 305M0030AM drill fit in my existing micro-drill chuck or quick-change adapter?
The 0.30 mm shank is standard for micro-tool holders; verify your chuck or adapter accepts 0.30 mm diameter before use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
