M.A. Ford
M.A. Ford 305M0030 Twister Micro-Tuff Drill 0.30Mm pneumatic accessory
Twister Micro-Tuff Drill with 0.30 mm diameter for precision pneumatic drilling
- Precision drilling with 0.30 mm micro diameter
- Micro-Tuff coating extends tool life in tough materials
- Twister flute design improves chip evacuation
- M.A. Ford manufacturing ensures consistent quality
- California Prop 65 compliance disclosed for safety awareness
Micro-Tuff Drill 0.30 mm
The M.A. Ford 305M0030 Twister Micro-Tuff Drill is a precision pneumatic accessory for fine hole-making tasks. Its 0.30 mm diameter suits electronics, instrumentation and micro-mechanical assembly where standard drills are too large. The tool is supplied new and ships direct from the manufacturer. California Proposition 65 warnings apply for cancer and reproductive-harm substances.
Sustained-load behaviour
The Micro-Tuff construction resists deflection and heat build-up during repeated peck-drilling cycles in abrasive or work-hardening materials. Consistent chip evacuation reduces the risk of breakage when the drill is run continuously in automated or CNC pneumatic spindles. Operators can maintain feed rates longer without frequent tool changes.
Upgrade path
This drill replaces worn or broken micro drills of the same 0.30 mm size in existing pneumatic setups. The jump is worth it when the current tool fails to hold tolerance or snaps under high-cycle loads. It does not address needs for larger diameters, coolant-through capability or non-pneumatic shank styles.
Highlights
- Precision drilling with 0.30 mm micro diameter
- Micro-Tuff coating extends tool life in tough materials
- Twister flute design improves chip evacuation
- M.A. Ford manufacturing ensures consistent quality
- California Prop 65 compliance disclosed for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 0.30 mm Twister Micro-Tuff Drill generate noticeable heat or vibration during extended pneumatic use?
The 0.30 mm drill is designed for precision micro-drilling with a pneumatic drive; heat and vibration levels depend on air pressure, feed rate and workpiece material rather than the bit alone.
What pneumatic tooling or collet system is required to run this 0.30 mm drill?
A compatible micro-collet or chuck capable of gripping a 0.30 mm shank and a regulated compressed-air supply are needed to operate the Twister Micro-Tuff Drill.
Will the 0.30 mm drill fit in older M.A. Ford micro-drill holders or quick-change adapters?
Fit depends on the holder’s minimum clamping diameter; any legacy holder that accepts a 0.30 mm shank will accept this Twister Micro-Tuff Drill.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
