M.A. Ford
M.A. Ford 30020310 Twister GP 5X Drill 13/64
A 13/64 inch Twister GP 5X drill bit with a straight shank for general-purpose drilling
- M.A. Ford brand trusted for professional drilling quality
- Twister GP 5X design optimised for efficient chip removal
- Straight shank fits standard drill chucks securely
- 13/64 inch diameter suits precise hole-making tasks
- New condition ensures full factory performance from first use
Twister GP 5X Drill 13/64
The M.A. Ford 30020310 Twister GP 5X Drill is a straight-shank cutting tool sized at 13/64 inch. It is built for machine shops and maintenance teams that need a reliable drill for general-purpose metalworking.
Proposition 65 warnings included
The supplier notes two California Proposition 65 warnings for this item. One warns of a chemical known to cause cancer and the other warns of a chemical known to cause birth defects or other reproductive harm.
Check shank compatibility first
Verify that your drill press or handheld drill accepts a straight shank of this diameter before ordering. Buyers who need a reduced shank or a different flute length should look for an alternative specification.
Highlights
- M.A. Ford brand trusted for professional drilling quality
- Twister GP 5X design optimised for efficient chip removal
- Straight shank fits standard drill chucks securely
- 13/64 inch diameter suits precise hole-making tasks
- New condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
When will the 13/64 Twister GP 5X drill need replacing?
Replace the drill when the cutting edges show visible wear, chipping or when hole quality drops below the tolerance required for the job.
What limits continuous drilling with the 13/64 Twister GP 5X?
Heat buildup in the cutting zone is the first limit; without adequate coolant or peck cycles the flutes lose clearance and the drill stalls.
How hot or noisy does the 13/64 Twister GP 5X get during all‑day use?
The drill itself runs at spindle speed, so noise and heat depend on the machine, feed rate and coolant; expect normal high‑speed drilling sound and warm shanks.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
