M.A. Ford
M.A. Ford 30012010 Twister GP 5X Drill 3.05mm
A 3.05 mm Twister GP 5X drill bit with straight shank for precision drilling
- M.A. Ford quality for reliable drilling performance
- 05 mm diameter for precise hole sizing
- Twister GP 5X design optimised for efficient material removal
- Straight shank ensures secure fit in standard chucks
- New condition guarantees full factory specification
Twister GP 5X Drill 3.05mm
The M.A. Ford 30012010 Twister GP 5X Drill is a straight-shank cutting tool sized at 3.05 mm. It is built for machinists and technicians who need precise holemaking in a variety of materials. The drill suits general-purpose workshop applications where consistent diameter control matters.
Replaces worn or undersized drill bits
This drill replaces dull or damaged bits that no longer hold tolerance or produce clean holes. The upgrade is worth it when hole accuracy falls below spec or when cycle times increase due to poor chip evacuation. It restores reliable cutting performance for the 3.05 mm diameter required.
Straight shank fits standard holders
The straight shank installs directly into standard drill chucks and collets without adapters. Common issues include excessive runout from worn tool holders and premature wear if coolant or lubrication is neglected. Proper clamping pressure and alignment prevent breakage at this diameter.
Highlights
- M.A. Ford quality for reliable drilling performance
- 05 mm diameter for precise hole sizing
- Twister GP 5X design optimised for efficient material removal
- Straight shank ensures secure fit in standard chucks
- New condition guarantees full factory specification
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size do I need for the 3.05 mm straight shank?
Use a drill chuck that accepts a 3.05 mm straight shank; tighten evenly to prevent run-out.
How do I install the Twister GP 5X drill without snapping the 3.05 mm shank?
Clamp the workpiece, start at low RPM, apply steady pressure, and avoid side loads that bend the narrow shank.
When should I replace the 3.05 mm Twister GP 5X drill?
Replace it when the cutting lips are chipped, the margin is worn, or the drill walks instead of centring cleanly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
