M.A. Ford
M.A. Ford 30009650 Twister GP 5X Drill 2.45 mm
Twister GP 5X drill with 2.45 mm straight shank for precision drilling
- Precision drilling with 5× performance geometry
- 45 mm straight shank for accurate fit
- M.A. Ford 30009650 Twister GP 5X design
- California Prop 65 chemical warning applies
- New condition, ready for immediate use
2.45 mm Twister GP 5X drill
The M.A. Ford 30009650 is a 2.45 mm diameter Twister GP 5X drill bit with a straight shank. It is designed for general-purpose drilling in metal and other materials where a precise 2.45 mm hole is required. The bit is supplied new and is suited to workshop and maintenance tasks that call for this specific diameter.
Straight-shank installation and common issues
The straight shank fits directly into a standard drill chuck without the need for a special holder or adapter. Tighten the chuck evenly on the flats to prevent the bit from slipping during use. Problems usually arise when the chuck is not fully secured or when the workpiece is not clamped, causing the drill to walk or the shank to spin in the jaws.
Behaviour under sustained drilling
Under continuous drilling the bit maintains its cutting geometry while heat builds in the cutting zone. Using cutting fluid or periodic withdrawal helps manage temperature and clears chips from the flutes. The tool is not intended for high-volume production runs where dedicated coolant-fed or carbide tooling would be specified.
Highlights
- Precision drilling with 5× performance geometry
- 45 mm straight shank for accurate fit
- M.A. Ford 30009650 Twister GP 5X design
- California Prop 65 chemical warning applies
- New condition, ready for immediate use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How can I confirm the 2.45 mm Twister GP 5X drill is cutting correctly after setup?
The drill should produce a clean, round hole at the rated 2.45 mm diameter with minimal burr and consistent chip evacuation when run at the recommended speed for the workpiece material.
What is included with the 30009650 Twister GP 5X drill and what must I supply?
The package contains the 2.45 mm straight-shank Twister GP 5X drill only; you must provide a compatible drill chuck or collet, cutting fluid or lubricant, and the workpiece fixturing.
Which Twister GP 5X version should I choose for a 2.45 mm hole?
Select the 30009650 model, which is manufactured specifically at 2.45 mm diameter; other part numbers correspond to different diameters.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
