M.A. Ford
M.A. Ford 30009250 Twister Gp 5X Drill 2.35 mm
A 2.35 mm Twister Gp 5X drill bit with straight shank for precision drilling
- Precision drilling with 2.35 mm straight shank
- Twister GP 5X geometry for efficient material removal
- M.A. Ford quality for reliable performance
- New condition ensures full tool life
- California Prop 65 compliance disclosed for safety awareness
M.A. Ford Twister Gp 5X Drill 2.35 mm
The M.A. Ford 30009250 Twister Gp 5X Drill is a 2.35 mm straight-shank cutting tool built for precision hole-making. It suits machinists and fabricators who need consistent performance in production or maintenance work. The drill is supplied new and ready for immediate use in compatible drill presses or hand-held units.
Straight-shank design and Prop 65 notice
The straight shank fits standard collets and three-jaw chucks without adapters, simplifying tool changes on the shop floor. California Proposition 65 warnings indicate the product contains chemicals known to the state to cause cancer and reproductive harm, so appropriate handling and ventilation practices should be followed during operation.
Manufacturer-direct fulfilment for orders over 75
Orders of 75 or more ship free directly from M.A. Ford, reducing lead time and ensuring the drill arrives in original factory packaging. No additional accessories or software are bundled with the drill, so users should verify coolant, work-holding and speed-feed requirements for their specific material before cutting.
Highlights
- Precision drilling with 2.35 mm straight shank
- Twister GP 5X geometry for efficient material removal
- M.A. Ford quality for reliable performance
- New condition ensures full tool life
- California Prop 65 compliance disclosed for safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank standard does the 30009250 Twister Gp 5X Drill use, and what chuck size does it require?
It uses a straight shank that fits a 2.35 mm chuck or larger adjustable collet.
What physical clearance does the 2.35 mm drill need to mount in a drill press or hand drill?
The shank diameter is 2.35 mm, so the chuck jaws must open at least that wide and the spindle run-out should be minimal.
How is the Twister Gp 5X Drill installed, and what step do users often miss?
Insert the straight shank fully into the chuck, tighten evenly on all jaws, and verify the bit runs true before drilling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
