M.A. Ford
M.A. Ford 30007480 Twister GP 5X Straight Shank Drill 1.90mm
A 1.90 mm straight-shank drill bit for precision drilling in metal and other materials
- Precision 1.90 mm drilling for tight-tolerance holes
- Twister GP 5X geometry improves chip evacuation and tool life
- Straight shank fits standard chucks and collets directly
- M.A. Ford quality construction for reliable performance in production
- California Proposition 65 listed — contains chemicals known to cause cancer and reproductive harm
1.90 mm Twister GP 5X drill
The M.A. Ford 30007480 is a 1.90 mm straight-shank drill from the Twister GP 5X range. It is intended for general-purpose drilling in metal, plastic and wood where a 1.90 mm hole is required. The tool is supplied new and carries the manufacturer's Proposition 65 notices for California.
Capacity and headroom
The 1.90 mm diameter determines the maximum hole size this bit produces; it cannot enlarge an existing hole beyond that dimension. It handles shallow to medium-depth drilling in softer materials but runs out of reach in deep-hole applications or when a larger diameter is needed.
Straight-shank practical limits
The straight shank fits standard three-jaw chucks and collets but cannot be used in SDS or taper-lock holders without an adapter. The shank length and flute geometry limit the usable drilling depth, so the bit is unsuitable for through-holes that exceed its effective flute length.
Highlights
- Precision 1.90 mm drilling for tight-tolerance holes
- Twister GP 5X geometry improves chip evacuation and tool life
- Straight shank fits standard chucks and collets directly
- M.A. Ford quality construction for reliable performance in production
- California Proposition 65 listed — contains chemicals known to cause cancer and reproductive harm
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 1.90 mm straight shank fit the keyless chuck I already use on my drill driver?
The 1.90 mm straight shank is sized for standard keyless chucks that accept 2 mm capacity, so it will seat securely in most common drill drivers.
How can I confirm the Twister GP 5X drill is cutting correctly once I start drilling?
A properly sharpened 1.90 mm drill produces a clean, round hole with minimal burr and consistent chip evacuation; if the hole is oversize or the drill chatters, resharpen or replace it.
Does the 30007480 package include any lubricant or only the drill bit itself?
The box contains the single 1.90 mm Twister GP 5X drill bit; cutting fluid or lubricant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
