M.A. Ford
M.A. Ford 30005310 Twister Gp 5X drill, 1.35 mm
A 1.35 mm straight-shank Twister GP 5X drill bit for precision hole-making in metal
- Twister Gp 5X drill, 1.35 mm diameter
- Straight shank fits standard drill chucks
- M.A. Ford brand precision manufacturing
- Model 30005310 for exact identification
- California Proposition 65 chemical warning applies
Twister Gp 5X drill, 1.35 mm
The M.A. Ford 30005310 is a straight-shank Twister Gp 5X drill with a 1.35 mm diameter. It is made for precision drilling in general-purpose workshop applications where a small-diameter tool is required.
California Proposition 65 notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. The warning applies to the item as supplied and does not describe a performance limit of the drill itself.
Installation and common issues
The straight shank fits standard drill chucks and collets for quick tool changes. Ensure the shank is fully seated and tightened to prevent run-out or slippage during operation. Use appropriate speed and feed rates for the workpiece material to avoid premature wear or breakage.
Highlights
- Twister Gp 5X drill, 1.35 mm diameter
- Straight shank fits standard drill chucks
- M.A. Ford brand precision manufacturing
- Model 30005310 for exact identification
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Is the 1.35 mm Twister Gp 5X drill the right size for my job?
The 1.35 mm diameter suits holes of that exact size; choose a different diameter if your fastener or clearance requires a larger or smaller hole.
How does the 5X designation affect drilling performance?
The 5X label indicates a flute length roughly five times the 1.35 mm diameter, giving deeper chip clearance than a standard jobber drill of the same width.
What does the straight shank mean for tool holding?
A straight shank fits standard three-jaw chucks and collets without a special taper, so it works in most drill presses and hand drills that accept 1.35 mm shanks.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
