M.A. Ford
M.A. Ford 30001970 Twister Gp 5X Drill 0.50 mm
A 0.50 mm Twister GP 5X drill bit with straight shank for precise drilling
- Precision drilling with 0.50 mm straight shank
- Twister Gp 5X geometry for clean holes
- M.A. Ford brand trusted by professionals
- New condition ensures full factory performance
- Manufacturer part number 30001970 for exact identification
0.50 mm Twister Gp 5X Drill
This M.A. Ford drill bit has a straight shank and a 0.50 mm diameter. It is manufactured under part number 30001970 and sold as a new item. The tool is intended for precision drilling tasks where a very small cutting diameter is required.
California Proposition 65 notice
The product carries a California Proposition 65 warning for exposure to a chemical known to cause cancer. A second Proposition 65 warning covers a chemical known to cause birth defects or other reproductive harm. Buyers who require documentation free of these declarations should verify compliance before purchase.
Straight shank installation notes
The straight shank fits standard drill chucks and collets that accept the 0.50 mm shank diameter. Because the cutting diameter is extremely small, run-out and excessive feed pressure can cause breakage. Users without rigid toolholding or coolant control may find the bit difficult to use reliably.
Highlights
- Precision drilling with 0.50 mm straight shank
- Twister Gp 5X geometry for clean holes
- M.A. Ford brand trusted by professionals
- New condition ensures full factory performance
- Manufacturer part number 30001970 for exact identification
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Should I choose the 0.50 mm Twister Gp 5X drill or a different diameter for my application?
The 0.50 mm diameter suits fine-hole drilling in metals and composites; select a larger size only if the hole specification requires it.
What does the 5X designation mean when the drill is in the machine?
The 5X label indicates a flute length roughly five times the 0.50 mm diameter, giving deeper reach before pecking is needed.
How does the straight shank interface limit use in a CNC spindle or drill chuck?
The straight shank fits standard collets and three-jaw chucks directly, but it cannot be used in taper-only tool holders without an adapter.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
