M.A. Ford
M.A. Ford 2XDSS6496A Twister Xd 3X Solid Carbide Drill 16.50Mm pneumatic accessory
Solid carbide Twister XD drill cuts 16.50 mm holes in tough materials with 3× diameter reach
- Solid carbide construction resists wear during high-speed drilling
- Twister XD 3X geometry improves chip evacuation in deep holes
- 50 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 notice included for regulatory awareness
Twister Xd 3X solid carbide drill
The M.A. Ford Twister Xd 3X is a solid carbide drill designed for high-performance drilling in tough materials. Its 16.50 mm diameter suits precision holemaking in automotive, aerospace and general engineering workshops. The tool is supplied new and ships directly from the manufacturer.
Upgrading from general-purpose HSS drills
Switching to this carbide drill is worthwhile when hole quality, tool life and cutting speed in hardened steels or high-temperature alloys exceed what high-speed steel can deliver. The 3X geometry reduces thrust and improves chip evacuation, so the jump pays off in repeatable production runs rather than occasional maintenance tasks.
Sustained cutting performance
Under continuous load the solid carbide body maintains rigidity and heat resistance far better than cobalt or HSS alternatives, keeping diameter tolerance stable over long cycles. The proprietary Twister Xd flute form evacuates chips efficiently, preventing packing that would otherwise spike torque and shorten tool life.
Highlights
- Solid carbide construction resists wear during high-speed drilling
- Twister XD 3X geometry improves chip evacuation in deep holes
- 50 mm diameter suits precise metric hole requirements
- M.A. Ford manufacturing delivers consistent cutting performance
- California Proposition 65 notice included for regulatory awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size collet or chuck is required to hold the 16.50 mm Twister Xd drill?
Use a collet or drill chuck that grips a 16.50 mm shank securely; the drill is solid carbide with no reduced-diameter shank, so the holder must accept the full 16.50 mm diameter.
What is the correct way to install the 16.50 mm solid-carbide drill in a pneumatic holder, and what step is often missed?
Clean the shank and holder bore, seat the drill fully so the shank bottoms out, then tighten the collet or chuck evenly; the step often missed is verifying zero run-out before starting the air motor.
When should the 16.50 mm Twister Xd drill be replaced?
Replace the drill when the cutting edges show visible wear, chipping, or when hole diameter exceeds tolerance and thrust force increases noticeably during drilling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
