M.A. Ford
M.A. Ford 2XDSR3189A Twister Xd 5X Solid Carbide Drill 8.10Mm pneumatic accessory
Solid carbide drill delivers five-times-diameter depth in an 8.10 mm size
- Solid carbide construction resists wear for longer tool life
- 5X diameter drilling depth reaches deeper holes in one pass
- 10 mm diameter suits precise machining applications
- Twister Xd geometry improves chip evacuation during operation
- New condition ensures full performance from first use
8.10 mm Twister XD 5X drill
The M.A. Ford 2XDSR3189A Twister XD 5X is a solid carbide drill with an 8.10 mm cutting diameter. It is built for high-performance drilling in demanding materials. Professional machinists and maintenance technicians use it for precise hole-making. The tool is supplied new and ships directly from the manufacturer.
Suited for deep-hole carbide drilling
This drill suits workshops that need a 5X diameter solid carbide tool for accurate deep-hole work. It is not intended for hand-held use or for jobs that require a larger diameter than 8.10 mm. Buyers who need coolant-through capability or a different flute length should look at other models. The California Proposition 65 notice also applies to this item.
Straightforward collet or chuck mounting
Installation consists of securing the 8.10 mm shank in a matched collet or drill chuck on a rigid machine spindle. Run-out should be checked before cutting to avoid premature wear. The most common issue is vibration caused by insufficient workpiece clamping or incorrect speed and feed settings. Proper coolant flow helps prevent built-up edge and extends tool life.
Highlights
- Solid carbide construction resists wear for longer tool life
- 5X diameter drilling depth reaches deeper holes in one pass
- 10 mm diameter suits precise machining applications
- Twister Xd geometry improves chip evacuation during operation
- New condition ensures full performance from first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck or collet is required to hold the 8.10 mm shank of this Twister XD drill?
Use a chuck or collet that closes fully to 8.10 mm; a standard 10 mm or 3/8 in chuck will not grip the shank securely.
Can the 5×D flute length of this solid-carbide drill be used in a shorter drilling cycle without changing peck settings?
The 5×D flute length is designed for deep-hole drilling in one pass; for shallower holes you can reduce the programmed depth but keep the same peck cycle if your controller requires it.
How can I confirm the drill is cutting correctly after the first hole?
Check that the hole diameter measures 8.10 mm, the wall finish is smooth without chatter marks, and the chips exit as tight curls rather than powder.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
