M.A. Ford
M.A. Ford 2MDCL1083A Twister Coolant 10X Micro Drill 2.75mm pneumatic accessory
A 2.75 mm micro drill with 10X coolant-through capability for precise pneumatic drilling
- Twister Coolant design enables 10X drilling depth for faster micro-hole production
- 75 mm diameter suits precision automotive and tooling applications
- M.A. Ford manufacturing delivers consistent micro-drill performance in pneumatic tools
- California Proposition 65 warning alerts users to cancer and reproductive-harm chemicals
- New condition ensures full factory specification on first use
Micro drill for precision holes
The M.A. Ford Twister Coolant 10X Micro Drill is a pneumatic accessory built for creating 2.75 mm holes with internal coolant delivery. It serves machinists and technicians who need accurate small-diameter drilling in metalworking applications.
10X diameter reach with coolant feed
The tool provides a 10 times diameter drilling depth, giving ample reach for deep micro-holes while the through-coolant design evacuates chips and manages heat. It runs out when hole diameters exceed 2.75 mm or when the machine lacks coolant-through capability.
Coolant-through shank for daily use
The integrated coolant channel reduces tool wear and improves hole finish during extended runs, meaning fewer tool changes and less downtime. The proprietary Twister geometry targets chip control in tough alloys, though the Proposition 65 notice indicates the presence of regulated substances that require standard shop safety practices.
Highlights
- Twister Coolant design enables 10X drilling depth for faster micro-hole production
- 75 mm diameter suits precision automotive and tooling applications
- M.A. Ford manufacturing delivers consistent micro-drill performance in pneumatic tools
- California Proposition 65 warning alerts users to cancer and reproductive-harm chemicals
- New condition ensures full factory specification on first use
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 2.75 mm Twister Coolant 10X Micro Drill fit the chuck on my older pneumatic drill motor?
The 2.75 mm shank is sized for standard micro-drill chucks; verify your motor's collet range includes 2.75 mm before use.
How do I confirm the 10X coolant-through feature is flowing correctly after installation?
Run the tool at low pressure and watch for a steady coolant stream exiting the 2.75 mm drill tip; no flow means a blockage or loose fitting.
Does the 2MDCL1083A package include collets or coolant fittings, or must I buy them separately?
The box contains only the 2.75 mm Twister Coolant 10X Micro Drill; collets and coolant supply fittings are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
