M.A. Ford
M.A. Ford 22925700 Twister Al 5X 3 Flute Drill
A five-times-diameter three-flute drill for aluminium machining, model 22925700
- Twister Al 5X design optimised for aluminium drilling
- Three-flute geometry improves chip evacuation and hole finish
- M.A. Ford 22925700 manufactured to professional tooling standards
- New condition guarantees full factory performance and reliability
- California Proposition 65 warning informs safe handling practices
M.A. Ford Twister Al 5X Drill
The M.A. Ford Twister Al 5X is a three-flute drill designed for aluminium machining. It serves CNC operators and maintenance teams who need reliable hole-making in non-ferrous materials. The tool carries manufacturer part number 22925700.
Upgrading from standard two-flute drills
Moving to this three-flute design increases chip evacuation capacity in aluminium workpieces. The jump is worth it when cycle time and surface finish matter more than the lower cost of conventional drills. It replaces tools that struggle with built-up edge.
Capacity and headroom in aluminium
The 5X geometry handles high feed rates in soft alloys without clogging. It runs out when the application demands drilling in hardened steels or exotic alloys beyond aluminium. California Proposition 65 warnings apply to this product.
Highlights
- Twister Al 5X design optimised for aluminium drilling
- Three-flute geometry improves chip evacuation and hole finish
- M.A. Ford 22925700 manufactured to professional tooling standards
- New condition guarantees full factory performance and reliability
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What tool holder or collet accepts the shank on the M.A. Ford 22925700 Twister Al 5X 3 Flute Drill?
The drill has a standard round shank designed for drill chucks or collets that match the shank diameter; select a holder that grips the shank securely without over-tightening.
What is the correct way to install this 3-flute drill in a CNC or manual machine to avoid run-out?
Clean the shank and holder bore, insert the drill fully so the flutes clear the chuck jaws, and tighten evenly; the step often missed is verifying concentricity with a dial indicator before cutting.
When should the M.A. Ford 22925700 Twister Al 5X drill be replaced or re-sharpened?
Replace or re-sharpen when flank wear reaches the manufacturer’s wear limit, when hole size drifts out of tolerance, or when thrust force and vibration increase noticeably during aluminium drilling.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
