M.A. Ford
M.A. Ford 22642910 Twister Gp 3X Drill 10.90mm power pneumatic accessory
10.90 mm Twister GP 3X drill bit for high-performance power and pneumatic drilling applications
- 90 mm diameter suits precise drilling tasks
- Twister GP 3X geometry supports efficient material removal
- M.A. Ford manufacturing delivers reliable cutting performance
- Power and pneumatic accessory fits compatible tool systems
- California Proposition 65 warning indicates chemical safety awareness
10.90 mm Twister GP 3X Drill
The M.A. Ford 22642910 is a 10.90 mm Twister GP 3X drill designed for power and pneumatic tool users. It serves workshops and technicians who need a dedicated accessory for drilling operations in metal or composite materials.
Sustained drilling performance
The Twister GP 3X geometry is engineered to maintain cutting efficiency during extended drilling cycles rather than only in short bursts. Its flute design promotes consistent chip evacuation, helping to reduce heat buildup and wear when the tool is run continuously under load.
Pre-purchase checks
Verify that your power or pneumatic tool accepts a 10.90 mm shank and that the chuck or collet can secure it safely. Confirm the workpiece material matches the drill’s intended application range. Note the California Proposition 65 warning regarding chemicals known to cause cancer and reproductive harm.
Highlights
- 90 mm diameter suits precise drilling tasks
- Twister GP 3X geometry supports efficient material removal
- M.A. Ford manufacturing delivers reliable cutting performance
- Power and pneumatic accessory fits compatible tool systems
- California Proposition 65 warning indicates chemical safety awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 10.90 mm drill generate noticeable heat during extended use?
The drill is a solid cutting accessory without moving parts, so it does not produce heat on its own; any warmth comes from the workpiece and cutting speed.
What tool must I already have to use the 10.90 mm Twister Gp 3X Drill?
You need a power drill or drill press with a chuck that accepts a 10.90 mm shank.
Will the 10.90 mm drill work in an older drill press that only takes smaller shanks?
No, the machine's chuck must open wide enough to grip the 10.90 mm shank; older units with smaller capacity cannot hold it.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
