M.A. Ford
M.A. Ford 22640550 Twister Gp 3X Drill 10.30mm pneumatic accessory
Twister Gp 3X Drill creates 10.30 mm holes in metal with pneumatic power
- Precision drilling with Twister Gp 3X geometry
- 30 mm diameter suits targeted hole sizes
- M.A. Ford 22640550 built for pneumatic power tools
- New condition ensures full factory performance
- California Proposition 65 chemical warning applies
10.30 mm Twister Gp 3X Drill
The M.A. Ford 22640550 is a pneumatic accessory built for high-speed drilling in metalworking and fabrication shops. Its Twister Gp 3X geometry is designed to reduce thrust and improve chip evacuation during continuous use. The 10.30 mm diameter suits precise hole-making in structural steel and alloy components.
Suited for production drilling on pneumatic rigs
This drill serves operators who need consistent performance on fixed-spindle pneumatic machines in industrial environments. It is not intended for hand-held cordless tools, low-pressure air systems or applications requiring coolant-through capability. Buyers who need a shank style other than the standard configuration should verify fitment before ordering.
Direct fit into compatible pneumatic holders
Installation consists of seating the shank into a matching collet or chuck on the pneumatic spindle and securing it per the machine builder’s procedure. The most common issue is running the tool at pressures or speeds outside the recommended range, which can cause premature wear or breakage. Ensure the air supply is clean, dry and regulated to the specification for the holder being used.
Highlights
- Precision drilling with Twister Gp 3X geometry
- 30 mm diameter suits targeted hole sizes
- M.A. Ford 22640550 built for pneumatic power tools
- New condition ensures full factory performance
- California Proposition 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What pneumatic tool do I need to run the 22640550 Twister Gp 3X Drill?
A pneumatic drill or rotary tool with a chuck that accepts a 10.30 mm shank and delivers the air pressure and flow the manufacturer specifies for this bit.
Can I use the 22640550 Twister Gp 3X Drill in a standard 10 mm keyed chuck?
No, the 10.30 mm shank exceeds a 10 mm chuck capacity; you need a chuck rated for at least 10.30 mm.
How do I confirm the 22640550 Twister Gp 3X Drill is cutting correctly after setup?
The bit should produce a clean hole at the rated diameter with steady chip evacuation and no excessive vibration or chatter during the cut.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
