M.A. Ford
M.A. Ford 22633850 Twister Gp 3X Drill 8.60 mm pneumatic accessory
Twister Gp 3X Drill creates 8.60 mm holes in metal, wood or plastic with pneumatic power
- Twister Gp 3X geometry enables faster material removal
- 60 mm diameter suits precise drilling tasks
- M.A. Ford brand delivers professional-grade reliability
- New condition ensures full cutting performance from first use
- California Proposition 65 warning informs safe handling practices
8.60 mm Twister Gp 3X Drill
The M.A. Ford 22633850 is a pneumatic accessory built for precision drilling in professional workshops. Its 8.60 mm diameter suits tasks that demand consistent hole quality across metal and composite materials. The tool arrives new and ships directly from the manufacturer. It is not for buyers who need a larger cutting diameter or a complete drill motor assembly.
Proposition 65 chemical notice
This product carries a California Proposition 65 warning for a chemical known to cause cancer and a chemical known to cause birth defects or other reproductive harm. The notice applies to the accessory itself and does not describe thermal behaviour, noise output or power consumption during use. No thermals, noise or power-draw data are provided for normal operation. Buyers who require quantified emissions or energy figures should look elsewhere.
8.60 mm cutting diameter
The single specification that determines fit is the 8.60 mm drill diameter, which must match the hole size required by the job and the chuck capacity of the pneumatic driver. The manufacturer part number 22633850 identifies this exact variant in the Twister Gp 3X series. It is not for operators who need a different diameter, a different shank style or a non-pneumatic cutting tool.
Highlights
- Twister Gp 3X geometry enables faster material removal
- 60 mm diameter suits precise drilling tasks
- M.A. Ford brand delivers professional-grade reliability
- New condition ensures full cutting performance from first use
- California Proposition 65 warning informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How is the 8.60 mm Twister Gp 3X Drill installed in a pneumatic tool, and what step is often missed?
Insert the 8.60 mm shank fully into the chuck or collet of the pneumatic drill and tighten securely; the step often missed is confirming the shank is seated past the retention groove before locking.
What maintenance or replacement will the 22633850 drill need during its service life?
The cutting edges will dull with use; resharpen the 8.60 mm drill point to the original geometry or replace the bit when resharpening no longer restores cutting performance.
What limit appears first when the Twister Gp 3X Drill is used continuously in a pneumatic tool?
Heat buildup at the 8.60 mm cutting zone is the first limit; sustained high-speed drilling without coolant or pauses causes temper loss and rapid edge wear.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
