M.A. Ford
M.A. Ford 22620860 Twister Gp 3X Drill 5.30Mm pneumatic accessory
5.30 mm Twister GP 3X drill bit for high-performance pneumatic drilling
- Twister Gp 3X design for high-efficiency drilling
- 30 mm diameter for precise hole sizing
- M.A. Ford brand trusted for professional tool quality
- New condition ensures full factory performance
- Part number 22620860 for exact ordering compatibility
M.A. Ford Twister Gp 3X Drill 5.30mm
The M.A. Ford 22620860 is a Twister Gp 3X drill bit with a 5.30 mm diameter. It is manufactured as a power and pneumatic accessory for use with compatible drilling equipment. The item is supplied new and ships directly from the manufacturer. This drill bit is intended for precision holemaking in industrial and automotive applications.
Suited for 5.30 mm holes; not for other diameters
This drill bit suits operators who require a 5.30 mm cutting diameter in a Twister Gp 3X geometry. It is not suitable for tasks requiring a different hole size or a different flute design. Buyers needing alternative diameters or lengths must select a different part number. The product carries a California Proposition 65 warning regarding chemicals known to cause cancer and reproductive harm.
5.30 mm cutting diameter decides fit
The single specification that determines whether this is the correct part is the 5.30 mm cutting diameter. Verify that your application calls for this exact size before ordering. The manufacturer part number 22620860 identifies this specific configuration. No other dimensions or performance figures are provided in the supplied data.
Highlights
- Twister Gp 3X design for high-efficiency drilling
- 30 mm diameter for precise hole sizing
- M.A. Ford brand trusted for professional tool quality
- New condition ensures full factory performance
- Part number 22620860 for exact ordering compatibility
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Does the 5.30 mm Twister Gp 3X Drill generate noticeable heat or vibration during extended pneumatic use?
The 5.30 mm Twister Gp 3X Drill is designed for pneumatic operation, so heat and vibration levels depend on the air supply pressure and the workpiece material rather than the accessory itself.
What pneumatic tool and air supply are required to run the 5.30 mm Twister Gp 3X Drill?
A compatible pneumatic drill or rotary tool with a 5.30 mm collet or chuck and a regulated compressed-air source are needed to operate the Twister Gp 3X Drill.
Can the 5.30 mm Twister Gp 3X Drill be used in a standard 1/4 inch collet on an older pneumatic drill?
The 5.30 mm shank diameter differs from a 1/4 inch collet, so a metric collet or adapter matching 5.30 mm is required for a secure fit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
