M.A. Ford
M.A. Ford 22618500 Twister Gp 3X Drill 4.70Mm pneumatic accessory
The Twister GP 3X drill bit bores 4.70 mm holes in metal with a three-flute design for faster chip removal
- Twister GP 3X geometry cuts faster in steel
- 70 mm diameter drills precise holes
- M.A. Ford brand trusted by machinists
- New condition delivers full tool life
- Prop 65 listed chemicals require safe handling
4.70 mm Twister GP 3X Drill
The M.A. Ford 22618500 is a pneumatic drill accessory built for precision hole-making at a 4.70 mm diameter. It suits technicians and engineers who need consistent results in metalworking or assembly tasks. The Twister GP 3X geometry supports efficient chip evacuation during operation. It is a new item supplied directly by the manufacturer.
Capacity and material limits
The 4.70 mm cutting diameter defines the hole size this tool produces in a single pass. It handles general-purpose drilling in ferrous and non-ferrous metals where that specific diameter is required. The tool runs out of capacity when a larger or smaller hole is needed, or when the workpiece material exceeds the hardness range for standard high-speed steel cutting edges. No other diameters are covered by this part number.
Included accessories and compliance
The product ships as a single drill accessory with no additional bits, lubricants or storage cases included. California Proposition 65 notices apply: the tool contains a chemical known to the state to cause cancer and a chemical known to cause birth defects or other reproductive harm. Orders of $75 or more qualify for free shipping from the manufacturer. No software or digital assets are bundled.
Highlights
- Twister GP 3X geometry cuts faster in steel
- 70 mm diameter drills precise holes
- M.A. Ford brand trusted by machinists
- New condition delivers full tool life
- Prop 65 listed chemicals require safe handling
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 4.70 mm Twister Gp 3X Drill fit the chuck on my older pneumatic drill?
The 4.70 mm shank matches standard drill chucks that accept metric sizes up to 5 mm; verify your chuck capacity before use.
How can I confirm the 22618500 drill is cutting correctly once installed?
It should produce consistent chip formation and a clean hole at the rated speed without excessive vibration or overheating.
Does the 22618500 package include any lubricant or only the drill bit itself?
The box contains the Twister Gp 3X Drill only; cutting fluid or coolant must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
