M.A. Ford
M.A. Ford 22616540 Twister Gp 3X Drill 4.20Mm pneumatic accessory
Twister GP 3X drill bit, 4.20 mm diameter, designed for high-performance drilling in power tools
- Twister Gp 3X geometry accelerates drilling in tough materials
- 20 mm diameter suits precise hole-making tasks
- M.A. Ford brand signals professional-grade cutting performance
- New condition ensures full factory specification and reliability
- California Proposition 65 notice informs safe handling practices
M.A. Ford Twister Gp 3X Drill 4.20Mm
The M.A. Ford Twister Gp 3X Drill is a pneumatic accessory built for precision drilling tasks. It carries the manufacturer part number 22616540 and is supplied in new condition. This tool suits workshops requiring a 4.20Mm cutting diameter.
Suited for 4.20Mm hole preparation
Machinists preparing a 4.20Mm hole will find this drill matches their requirement. It is not intended for operations needing a different diameter or a non-pneumatic shank style. Buyers who need a larger or smaller cutting size should look at something else.
4.20Mm cutting diameter
The single specification that decides fit is the 4.20Mm cutting diameter. Verify that your application calls for this exact size before ordering. The part number 22616540 confirms the specific tool variant.
Highlights
- Twister Gp 3X geometry accelerates drilling in tough materials
- 20 mm diameter suits precise hole-making tasks
- M.A. Ford brand signals professional-grade cutting performance
- New condition ensures full factory specification and reliability
- California Proposition 65 notice informs safe handling practices
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What pneumatic drill or driver is required to run the Twister Gp 3X 4.20 mm drill bit?
A pneumatic drill or driver with a chuck that accepts a 4.20 mm shank will drive the Twister Gp 3X bit.
Can the 4.20 mm Twister Gp 3X bit be used in an older pneumatic drill that only takes imperial shanks?
No, the 4.20 mm shank will not fit a chuck sized for imperial fractions without an adapter.
How can I confirm the Twister Gp 3X 4.20 mm bit is cutting correctly after installation?
The bit should produce clean, round holes at the rated diameter with steady chip evacuation and no excessive vibration.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
