M.A. Ford
M.A. Ford 22614570 Twister Gp 3X Drill 3.70 mm pneumatic accessory
The 3.70 mm Twister GP 3X drill bit cuts clean holes in metal and composite materials
- Twister Gp 3X design delivers efficient drilling
- 70 mm diameter suits precise hole sizes
- M.A. Ford brand ensures professional tool quality
- New condition guarantees full performance from first use
- Model 22614570 identifies exact replacement part
3.70 mm Twister Gp 3X Drill
This M.A. Ford drill bit carries part number 22614570 and measures 3.70 mm in diameter. It is a new pneumatic accessory intended for precision drilling in metalworking and maintenance tasks. The Twister Gp 3X designation identifies the specific flute geometry supplied by the manufacturer.
California Proposition 65 warning applies
The product contains a chemical identified by the State of California as a cause of cancer and a chemical identified as a cause of birth defects or other reproductive harm. Compliance with Proposition 65 is a regulatory requirement that accompanies this item. No other standards or certifications are referenced in the supplied data.
Direct manufacturer shipment
Orders valued at 75 or more ship free and the accessory ships directly from the manufacturer. The bit installs in any compatible pneumatic drill chuck that accepts a 3.70 mm shank. Misalignment or an oversized chuck are the typical causes of run-out or premature wear.
Highlights
- Twister Gp 3X design delivers efficient drilling
- 70 mm diameter suits precise hole sizes
- M.A. Ford brand ensures professional tool quality
- New condition guarantees full performance from first use
- Model 22614570 identifies exact replacement part
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Is the 3.70 mm diameter the only size offered for this Twister Gp 3X Drill?
The supplier lists only the 3.70 mm variant under part number 22614570.
What does the 3X designation mean for drilling performance?
The 3X label refers to the Twister Gp series geometry optimised for faster chip evacuation.
Does the drill use a standard shank that fits common pneumatic chucks?
The accessory is built for pneumatic tool holders; the exact shank style is not detailed in the listing.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
