M.A. Ford
M.A. Ford 20731600 Twister Brad and Spur Drill
Twister brad and spur drill 20731600 cuts clean starter holes in wood for accurate screw placement
- Brad-point tip starts holes cleanly without wandering
- Spur cutting edges shear wood fibres for smooth bore walls
- Twister flute geometry clears chips efficiently during deep drilling
- M.A. Ford manufacturing quality ensures consistent performance in wood
- California Proposition 65 warning applies to this product
Twister Brad and Spur Drill 20731600
The M.A. Ford 20731600 Twister Brad and Spur Drill is a new power-tool accessory designed for clean hole-making in wood. Its brad-point tip and twin spurs score the fibres before the cutting lips engage, reducing tear-out on entry and exit. Woodworkers and joiners who need accurate dowel or hinge holes will find the geometry suited to repeatable results.
Replaces worn brad-point bits
When an existing brad-point drill no longer leaves a crisp shoulder or begins to wander on hardwood, this bit restores the cutting action that defines the operation. The jump is worth it when tear-out on the back face of the workpiece becomes unacceptable for visible joinery or when the centre point fails to hold position on dense grain.
Sustained drilling in dense timber
Under continuous feed the twin spurs maintain a clean perimeter while the centre point prevents drift, keeping hole diameter consistent through the full depth. Heat build-up is managed by the open flute form, allowing the bit to complete multiple holes without the binding that stops a dull or clogged cutter.
Highlights
- Brad-point tip starts holes cleanly without wandering
- Spur cutting edges shear wood fibres for smooth bore walls
- Twister flute geometry clears chips efficiently during deep drilling
- M.A. Ford manufacturing quality ensures consistent performance in wood
- California Proposition 65 warning applies to this product
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What chuck size does the Twister Brad and Spur Drill 20731600 need to fit?
It fits a standard drill chuck that accepts its shank diameter; match the chuck capacity to the bit shank for secure mounting.
How is the Twister Brad and Spur Drill 20731600 installed, and what step do people get wrong?
Insert the bit fully into the chuck and tighten all three jaws evenly; the common error is leaving the shank short or tightening on only two jaws.
When will the Twister Brad and Spur Drill 20731600 need replacement?
Replace it when the cutting edges dull, the spur chips, or the brad point wears down and no longer starts clean holes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
