M.A. Ford
M.A. Ford 20724800 Twister Brad & Spur Drill 6.30 mm
Twister Brad & Spur drill bit creates clean, accurate 6.30 mm holes in wood
- Precision drilling with 6.30 mm Twister Brad & Spur bit
- Clean entry holes reduce splintering in wood and composites
- M.A. Ford manufacturing ensures consistent geometry and durability
- Prop 65 notice informs safe handling in regulated environments
- Part 20724800 identifies exact replacement for tooling setups
Twister Brad & Spur Drill 6.30 mm
The M.A. Ford Twister Brad & Spur Drill is a 6.30 mm cutting tool designed for clean, accurate holes in wood and similar materials. Its brad point centres the bit without wandering while the spur cutting edges shear fibres for a smooth bore. The drill is supplied new and carries the manufacturer part number 20724800.
Upgrade from standard twist bits
Switching to this brad and spur geometry eliminates the skating common with conventional twist drills on timber. The improvement is most noticeable when hole placement must be exact and tear-out on the exit side is unacceptable. The design also reduces the force needed to feed the bit through dense stock.
Woodworkers needing precise dowel or hinge holes
Cabinet makers and joiners who require repeatable 6.30 mm holes will benefit from the centred start and clean cut. Users who primarily drill metal, masonry or large-diameter bores should select a bit type engineered for those materials. The product carries a California Proposition 65 warning for chemicals linked to cancer and reproductive harm.
Highlights
- Precision drilling with 6.30 mm Twister Brad & Spur bit
- Clean entry holes reduce splintering in wood and composites
- M.A. Ford manufacturing ensures consistent geometry and durability
- Prop 65 notice informs safe handling in regulated environments
- Part 20724800 identifies exact replacement for tooling setups
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck does the 6.30 mm Twister Brad & Spur Drill require?
The drill has a 6.30 mm diameter shank, so it fits any standard chuck that accepts 6.30 mm round shanks.
How do you install the Twister Brad & Spur Drill without damaging the brad point?
Open the chuck fully, insert the shank until it seats, then tighten evenly by hand before final tightening with the key to keep the brad point centred.
When should the 20724800 drill be replaced?
Replace it when the cutting lips become dull, the brad point wears down, or the flutes clog and cannot clear chips cleanly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
