M.A. Ford
M.A. Ford 20632300 Twister Gp 3X Drill, P pneumatic accessory
Twister Gp 3X Drill pneumatic accessory for power tool drilling tasks, new condition
- Twister Gp 3X Drill designed for pneumatic power tools
- M.A. Ford brand trusted in professional automotive workshops
- New condition ensures full factory performance from first use
- Model 20632300 identifies exact replacement for maintenance orders
- California Proposition 65 notice included for workplace safety compliance
M.A. Ford Twister Gp 3X Drill P
This M.A. Ford Twister Gp 3X Drill is a pneumatic accessory built for power-tool users who need a reliable drilling attachment. It carries the manufacturer part number 20632300 and arrives in new condition. The product is classified under power and pneumatic accessories for automotive and general workshop use. California Proposition 65 warnings apply to this item.
Suited for pneumatic drilling tasks
This drill suits technicians and mechanics who operate pneumatic systems and require a compatible 3X drill accessory for their existing setup. It is not intended for buyers who need electric or battery-powered drill units, nor for those seeking a complete tool kit with multiple attachments. The accessory addresses a specific pneumatic connection requirement only.
Prop 65 chemical warning notice
California Proposition 65 warnings indicate this product contains a chemical known to the state to cause cancer and birth defects or other reproductive harm. Buyers who must avoid any item carrying these regulatory notices should select an alternative accessory. This warning is the decisive factor for compliance-sensitive purchasing decisions.
Highlights
- Twister Gp 3X Drill designed for pneumatic power tools
- M.A. Ford brand trusted in professional automotive workshops
- New condition ensures full factory performance from first use
- Model 20632300 identifies exact replacement for maintenance orders
- California Proposition 65 notice included for workplace safety compliance
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What pneumatic tool or compressor is required to run the Twister Gp 3X Drill?
The Twister Gp 3X Drill is a pneumatic accessory and must be driven by a compatible air compressor or pneumatic power tool that supplies the required air pressure and flow.
Will the Twister Gp 3X Drill fit the chuck or collet on my existing drill motor?
The Twister Gp 3X Drill is designed for pneumatic operation and mounts to a suitable pneumatic drill motor; verify the motor's chuck capacity matches the drill's shank before use.
How can I confirm the Twister Gp 3X Drill is cutting correctly after installation?
Check for smooth, consistent chip formation and a clean hole finish while the drill runs at the recommended air pressure; unusual vibration or rough cuts indicate a setup issue.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
