M.A. Ford
M.A. Ford 16514060 Tuffcut GP 4 flute ball nose stub 9/64
Four-flute ball-nose stub end mill cuts precise radii in a range of materials
- 4-flute design enables efficient material removal in stub-length cuts
- Ball-nose profile produces smooth contoured surfaces and radii
- Stub length increases rigidity for reduced deflection in shallow pockets
- M.A. Ford manufacturing delivers consistent geometry for repeatable results
- California Proposition 65 notice indicates regulated substances present
16514060 Tuffcut GP ball nose end mill
The M.A. Ford 16514060 is a four-flute ball nose end mill with a stub length profile. It is designed for general-purpose milling operations in a workshop or production environment. The tool suits machinists who need a rigid, short-reach cutter for contouring and profiling tasks.
Upgrade from two-flute or long-length cutters
Switching to this four-flute stub tool increases rigidity and reduces deflection compared with two-flute or longer alternatives. The jump is worthwhile when the workpiece allows a shorter projection and the material benefits from higher feed rates. It is not suited for deep-pocket work that demands extra reach.
Sustained load behaviour
The stub length and four-flute design maintain stability during extended cutting passes. Heat distributes across multiple cutting edges, supporting consistent material removal without excessive vibration. The tool is not intended for applications requiring long overhangs or light finishing cuts at low engagement.
Highlights
- 4-flute design enables efficient material removal in stub-length cuts
- Ball-nose profile produces smooth contoured surfaces and radii
- Stub length increases rigidity for reduced deflection in shallow pockets
- M.A. Ford manufacturing delivers consistent geometry for repeatable results
- California Proposition 65 notice indicates regulated substances present
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What collet or holder size accepts the 9/64 shank on this M.A. Ford 16514060 end mill?
Use a 9/64 inch collet or an ER collet with a matching 9/64 inch bore to grip the shank securely.
How do you install the stub-length ball nose cutter without breaking the flutes?
Clamp the tool by the shank only, keep overhang to the minimum needed, and tighten the collet nut to the holder manufacturer's torque spec.
When should the 4-flute ball nose cutter be replaced?
Replace it when the ball radius shows visible wear, chips appear on the cutting edges, or surface finish degrades on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
