M.A. Ford
M.A. Ford 156M0060N10A 0.60 mm 2 Flute Ball Nose End Mill
A 0.60 mm two-flute ball nose end mill with necked design for precision milling
- TypeCutting Tools
- Precision 0.60 mm ball nose for fine contours
- Two-flute design clears chips efficiently in tight spaces
- Necked shank improves reach without sacrificing rigidity
- TuffCut DM coating resists wear on abrasive materials
- California Prop 65 notice included for compliance awareness
Precision Milling Tool
The M.A. Ford 156M0060N10A is a 0.60 mm diameter, two-flute ball nose end mill with a necked design. It is engineered for precision contouring and finishing operations in detailed machining work. The small cutting diameter suits intricate profiles and tight radii. This tool is intended for machinists and manufacturers requiring fine detail capability.
Upgrade From Larger Cutters
This end mill replaces larger-diameter tools when feature size or corner radius demands a smaller profile. The jump is justified when part geometry cannot be accessed or finished accurately with standard sizes. The necked shank provides additional reach in deep cavities without increasing the cutting diameter. It addresses the need for finer resolution in complex three-dimensional surfaces.
Capacity And Limits
The 0.60 mm cutting diameter comfortably handles micro-scale profiling, engraving, and tight-radius finishing in a range of materials. Headroom is defined by the small flute length and neck relief, which limit axial depth per pass. The tool runs out when material removal rates require heavier chip loads or when workpiece features exceed the cutter’s reach and rigidity envelope.
Highlights
- Precision 0.60 mm ball nose for fine contours
- Two-flute design clears chips efficiently in tight spaces
- Necked shank improves reach without sacrificing rigidity
- TuffCut DM coating resists wear on abrasive materials
- California Prop 65 notice included for compliance awareness
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter does the 0.60 mm end mill need to fit my collet?
The 0.60 mm cutting diameter requires a matching collet or holder sized for that shank; verify your tool holder accepts the shank diameter before mounting.
How do I install the necked ball nose cutter without damaging the flutes?
Insert the tool fully into the collet, tighten evenly to avoid run-out, and ensure the necked section clears the workpiece — over-tightening or short clamping are the common errors.
When should I replace this 2 flute end mill?
Replace the cutter when the ball nose shows visible wear, chipping, or when cut quality drops; the California Proposition 65 notice applies to the tool material during disposal.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
